MX6SWT-A1-0000-000DA2 Ver la hoja de datos (PDF) - Cree, Inc

Número de pieza

componentes Descripción

Fabricante

MX6SWT-A1-0000-000DA2

Cree® XLamp® MX-6S LEDs

Cree, Inc 

XLamp® MX-6S LED

Notes - Continued

Storage Conditions

XLamp MX-6S LEDs that have been removed from the original MBP but not soldered should be stored in one of the following ways:

• Store the parts in a rigid metal container with a tight-fitting lid. Verify that the storage temperature is <30 °C, and place fresh desiccant

and an RH indicator in the container to verify that the RH is no greater than 60%.

• Store the parts in a dry, nitrogen‑purged cabinet or container that actively maintains the temperature at <30° and the RH at no greater

than 60%.

• For short-term store only: LEDs can be resealed in the original MBP soon after opening. Fresh desiccant may be needed. Use the

included humidity indicator card to verify <60% RH.

If an environment of <60% RH is not available for storage, XLamp MX-6S LEDs should be baked (described above) before reflow soldering.

RoHS Compliance

The levels of RoHS restricted materials in this product are below the maximum concentration values (also referred to as the threshold

limits) permitted for such substances, or are used in an exempted application, in accordance with EU Directive 2011/65/EC (RoHS2), as

implemented January 2, 2013. RoHS Declarations for this product can be obtained from your Cree representative or from the Product

Ecology section of the Cree website.

REACh Compliance

REACh substances of very high concern (SVHCs) information is available for this product. Since the European Chemical Agency (ECHA)

has published notice of their intent to frequently revise the SVHC listing for the foreseeable future, please contact a Cree representative to

insure you get the most up-to-date REACh SVHC Declaration. REACh banned substance information (REACh Article 67) is also available

upon request.

UL® Recognized Component

This product meets the requirements to be considered a UL Recognized Component with Level 4 enclosure consideration. The LED

package or a portion thereof has been investigated as a fire and electrical enclosure per ANSI/UL 8750.

Vision Advisory

WARNING: Do not look at an exposed lamp in operation. Eye injury can result. See LED For more information about LEDs and eye safety,

refer to the LED Eye Safety application note.

Copyright © 2010-2017 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree® and XLamp® are registered trademarks and the Cree logo is a trademark of

Cree, Inc. UL® and the UR logo are registered trademarks of UL LLC.

9

Share Link: