WM2618CD Ver la hoja de datos (PDF) - Wolfson Microelectronics plc

Número de pieza

componentes Descripción

Fabricante

WM2618CD

Dual 12-bit Serial Input Voltage Output DAC

Wolfson Microelectronics plc 

Production Data

WM2618

to the serial interface. Bit D14 can be zero to select slow mode or one to select fast mode.

The data (bits D0 to D11) are written to both the double buffer and latch B.

The latch A contents and the DAC A output are not changed by this write.

3. double buffered change of both DAC outputs

Assuming that DACs A and B start at zero code (e.g., after power up), if DAC A is to be

driven to mid-scale and DAC B to full-scale, and if the outputs are to begin rising at the same

time, this can be achieved as follows:

First,

0d01 1111 1111 1111

is written (bit D15 on the left, D0 on the right) to the serial interface. This loads the full-scale

code into the double buffer but does not change the latch B contents and the DAC B output

voltage. The latch A contents and the DAC A output are also unaffected by this write

operation.

Changing from fast to slow to fast mode changes the supply current which can glitch the

outputs, and so D14 (designated by d in the above data word) should be set to maintain the

speed mode set by the previous write.

Next,

1d0X 1000 0000 0000

is written (bit D15 on the left, D0 on the right) to the serial interface. The X in bit D12 can be

zero or one (don’t care). This writes the mid-scale code (100000000000) to latch A and also

copies the full-scale code from the double buffer to latch B. Both DAC outputs thus begin to

rise after the second write.

WOLFSON MICROELECTRONICS LTD

PD Rev 1.1 October 2000

9

Share Link: