25X16BVAIG Ver la hoja de datos (PDF) - Winbond

Número de pieza

componentes Descripción

Fabricante

25X16BVAIG

16M-BIT SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL OUTPUT SPI

Winbond 

W25X16BV

11.2.17 Read Manufacturer / Device ID (90h)

The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down/

Device ID instruction that provides both JEDEC assigned manufacturer ID and the specific device ID.

The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device

ID instruction. The instruction is initiated by driving the /CS pin low and shifting the instruction code

“90h” followed by a 24-bit address (A23-A0) of 000000h. After which, the Manufacturer ID for Winbond

(EFh) and the Device ID are shifted out on the falling edge of CLK with most significant bit (MSB) first

as shown in figure 19. The Device ID values for the W25X16BV are listed in Manufacturer and Device

Identification table. If the 24-bit address is initially set to 000001h the Device ID will be read first and

then followed by the Manufacturer ID. The Manufacturer and Device IDs can be read continuously,

alternating from one to the other. The instruction is completed by driving /CS high.

Figure 19. Read Manufacturer / Device ID Diagram

- 30 -

Share Link: