D[3:0]
CLKI
SDA
SCL
setup0[0]
setup0[2]
Frame
Number
N
FH
9H,6H,9H,6H...
One frame of 9H & 6H data.
FH
Start of Frame Line for the 1st
frame of valid video data.
Valid Video data.
0
1
2
3
4
5
SR0-SR1
SR2
SR3-SR4
SR5-SR6
SR7-SR8
“Soft-Reset” Command. At the end of the command the sensor is reset and enters low-power mode.
The sensor enters low-power mode.
“Exit Low Power Mode” Command. Powers-up analogue circuits and initiates the VM6404 sensor’s 4-frame start-up sequence
1 Frame of alternating 9H & 6H data on D[3:0] for the video processor to determine the best sampling phase for the nibble data
(D[3:0]).
4 Frames after the “Exit Low-Power mode” command, the sensor starts outputing valid video data.
Figure 9 : Resetting the VV6404 Sensor via the Serial Interface.