UPSD3233 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

UPSD3233

Flash Programmable System Devices with 8032 Microcontroller Core and 64 Kbit SRAM

STMicroelectronics 

uPSD3234A, uPSD3234BV, uPSD3233B, uPSD3233BV

Table 4. Arithmetic Instructions

Mnemonic

Operation

ADD A,<byte>

ADDC A,<byte>

SUBB A,<byte>

INC

INC <byte>

INC DPTR

DEC

DEC <byte>

MUL AB

DIV AB

DA A

A = A + <byte>

A = A + <byte> + C

A = A – <byte> – C

A=A+1

<byte> = <byte> + 1

DPTR = DPTR + 1

A=A–1

<byte> = <byte> – 1

B:A = B x A

A = Int[ A / B ]

B = Mod[ A / B ]

Decimal Adjust

Addressing Modes

Dir.

Ind.

Reg.

Imm

X

X

X

X

X

X

X

X

X

X

X

X

Accumulator only

X

X

X

Data Pointer only

Accumulator only

X

X

X

Accumulator and B only

Accumulator and B only

Accumulator only

Logical Instructions

Table 5., page 19 shows list of uPSD323X Devic-

es logical instructions. The instructions that per-

form Boolean operations (AND, OR, Exclusive

OR, NOT) on bytes perform the operation on a bit-

by-bit basis. That is, if the Accumulator contains

00110101B and byte contains 01010011B, then:

ANL A, <byte>

will leave the Accumulator holding 00010001B.

The addressing modes that can be used to access

the <byte> operand are listed in Table 5., page 19.

The ANL A, <byte> instruction may take any of the

forms:

ANL A,7FH(direct addressing)

ANL A, @R1 (indirect addressing)

ANL A,R6 (register addressing)

ANL A,#53H (immediate constant)

Note: Boolean operations can be performed on

any byte in the internal Data Memory space with-

out going through the Accumulator. The XRL

<byte>, #data instruction, for example, offers a

quick and easy way to invert port bits, as in

XRL P1, #0FFH.

If the operation is in response to an interrupt, not

using the Accumulator saves the time and effort to

push it onto the stack in the service routine.

The Rotate instructions (RL A, RLC A, etc.) shift

the Accumulator 1 bit to the left or right. For a left

rotation, the MSB rolls into the LSB position. For a

right rotation, the LSB rolls into the MSB position.

The SWAP A instruction interchanges the high

and low nibbles within the Accumulator. This is a

useful operation in BCD manipulations. For exam-

ple, if the Accumulator contains a binary number

which is known to be less than 100, it can be quick-

ly converted to BCD by the following code:

MOVE B,#10

DIV AB

SWAP A

ADD A,B

Dividing the number by 10 leaves the tens digit in

the low nibble of the Accumulator, and the ones

digit in the B register. The SWAP and ADD instruc-

tions move the tens digit to the high nibble of the

Accumulator, and the ones digit to the low nibble.

18/170

Share Link: