DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

PCD3316T/F2 Ver la hoja de datos (PDF) - Philips Electronics

Número de pieza
componentes Descripción
Fabricante
PCD3316T/F2
Philips
Philips Electronics Philips
PCD3316T/F2 Datasheet PDF : 30 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Philips Semiconductors
PCD3316
CIDCW receiver
7.9 The internal Power-on reset (POR)
The device contains an on-chip Power-on reset circuitry which activates a reset as
long as VDD is below a predefined level VPOR(H). If VDD exceeds VPOR(H), the
3.58 MHz oscillator will start. The PCD3316 is initialized and the internal registers are
U set to the default value (see Section 7.13). It takes a maximum of 100 cycles of the
3.58 MHz clock to initialize all internal functions. The POR circuitry also ensures, that
n the chip will be switched off as soon as a falling VDD reaches a predefined level
(VPOR(L)).
re7.10 3.58 MHz oscillator circuitry
sThe 3.58 MHz oscillator is needed for the FSK receiver and the CAS detection. This
on-chip Amplitude Controlled Oscillator (ACO) circuitry is a single-stage inverting
tramplifier biased by an internal feedback resistor Rfb. The oscillator circuit is shown in
Figure 5. When using a quartz resonator to drive the oscillator, normally no external
ic components are needed.
t When using ceramic resonators to drive the oscillator, in some cases external
e components are needed; refer to the ceramic resonator product specifications. Two
d different configurations are shown in Figure 6a and Figure 6b.
handbook, halfpage
AMPLITUDE
CONTROL
PCD3316
on/off
Rfb
C1i
1
HXIN
C2i
2
HXOUT
C1e
C2e
Fig 5. Oscillator.
MGK723
To drive the device with an external clock source, apply the external clock signal to
HXIN, and leave HXOUT to float, as shown in Figure 6c. If the amplitude of the input
signal is less than VDD to DGND or a sine wave is applied, capacitive decoupling is
needed as shown in Figure 6d.
In the Power-down mode (Mode register 2, bit 7 = 0), the oscillator is stopped and
HXIN and HXOUT are internally pulled LOW. The current of the whole oscillator is
switched off.
9397 750 04824
Product specification
11 March 1999
© Philips Electronics N.V. 1999. All rights reserved.
8 of 30

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]