TDA5632 Ver la hoja de datos (PDF) - Philips Electronics
Número de pieza
componentes Descripción
Fabricante
TDA5632 Datasheet PDF : 20 Pages
| |||
Philips Semiconductors
9 V VHF and UHF mixers/oscillators for
TV and VCR cable tuners
Product specification
TDA5632; TDA5633
FEATURES
• Balanced mixer with a common emitter input for band A
• 2-pin oscillator for band A
• Balanced mixer with a common base input for band C
• 4-pin oscillator for band C
• Local oscillator buffer output for external prescaler
• SAW filter preamplifier with a low output impedance to
drive a 75 Ω load
• Band gap voltage stabilizer for oscillator stability
• Electronic band switch
• External IF filter connected between the mixer output
and the IF amplifier input.
APPLICATIONS
• Cable tuners for TV and VTR; switched concept for VHF
• Recommended RF bands for Europe:
48.25 to 105.25 MHz, 112.25 to 294.25 MHz and
471.25 to 855.25 MHz
• Recommended RF bands for the USA:
55.25 to 133.25 MHz, 139.25 to 361.25 MHz and
367.25 to 801.25 MHz.
DESCRIPTION
The TDA5632 and TDA5633 are monolithic integrated
circuits that perform VHF and UHF mixer/oscillator
functions in TV and VCR cable tuners. With correct
oscillator application and by using a switchable inductor to
split the VHF band into two sub-bands, the full VHF/UHF
TV bands can be covered. These low-power
mixers/oscillators require a power supply of 9 V and are
available in a very small package.
The devices provide the designer with the capability to
design an economical and physically small cable tuner.
The tuner development time can be drastically reduced by
using this device.
Frequency bands are determined by the external tank
circuit. They can be adapted to various standards.
QUICK REFERENCE DATA
SYMBOL
VP
IP
fRF
PARAMETER
supply voltage
supply current
frequency range (picture carrier)
Gv
voltage gain
NF
noise figure
Vo
output voltage to obtain 1% cross
modulation in channel
CONDITIONS
RF input; band A; note 1
RF input; band C; note 1
band A (75 Ω load)
band C (75 Ω load)
band A (75 Ω load)
band C (75 Ω load)
band A (75 Ω load)
band C (75 Ω load)
MIN.
−
−
57.5
469.5
−
−
−
−
−
−
TYP.
9.0
40
−
−
19
30
10
9.5
110
110
MAX.
−
−
357.5
887.5
−
−
−
−
−
−
UNIT
V
mA
MHz
MHz
dB
dB
dB
dB
dBµV
dBµV
Note
1. The limits are related to the tank circuits used in Fig.10 and the intermediate frequency. Frequency bands may be
adjusted by the choice of external components. Another UHF frequency range is available by modifying the tank
circuit. The modification enables the following frequency range:
a) RF frequencies from 361.25 to 801.25 MHz (picture carrier).
b) Oscillator frequencies from 407 to 847 MHz. For this UHF range, L4 = 3 turns (diameter = 3.5 mm).
1996 Aug 16
2
Share Link: 