Terminal
No. Name
Function
・AM mode
AGC time constant is
determined by external
capacitor.
8
AGC
・FM mode
The sudden change of stop
pulse sensitivity is held in by
external capacitor.
9
GND
―
Output of IF count signal
In case of IF request mode, IF
10 IF OUT
count signal for IF counter is
taken from this terminal.
FM: VIF (FM) = 80mVp−p (typ.)
AM: VIF (AM) = 100mVp−p (typ.)
IF request switch
VCC: Receive mode
Open: IF request mode
11 IF REQ
FM stop pulse sensitivity can
be changed by connecting
RSEN in IF request mode.
RSEN should be smaller than
100kΩ
Output of stop pulse
VCO frequency can be
monitored, in case that this
12 SP OUT
terminal is connected with
GND through a resistor
(RVCO ≒ 100kΩ).
ON : VCO monitor
OPEN : SP OUT
Stereo indicator terminal
・This terminal shared with
output of modulated AM IF
signal.
13
ST IND
・AM IF output: 6mVrms
(RIF = 3kΩ, typ.)
・RIF should be smaller than
3kΩ. In case that RIF > 3kΩ,
internal biasing circuit doesn't
operate normally in AM mode.
TA2022AFNG
Internal Circuit
Terminal
Voltage (V)
AM FM
――
―
0
0
――
――
――
――
4
2006-04-11