DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

T35L3232B Ver la hoja de datos (PDF) - Taiwan Memory Technology

Número de pieza
componentes Descripción
Fabricante
T35L3232B
TMT
Taiwan Memory Technology TMT
T35L3232B Datasheet PDF : 19 Pages
First Prev 11 12 13 14 15 16 17 18 19
tm TE
CH
Preliminary T35L3232B
CAPACITANCE
DESCRIPTION
CONDITIONS
SYM. TYP MAX UNITS NOTES
Input Capacitance
Input/ Output
Capacitance(DQ)
TA = 25°C; f = 1 MHz CI
3
4
pF
4
VCC = 3.3V
CO
6
7
pF
4
THERMAL CONSIDERATION
DESCRIPTION
CONDITIONS
Thermal Resistance - Junction to Ambient Still air, soldered on
4.25x1.125 inch 4-layer
Thermal Resistance - Junction to Case
PCB
SYM. QFP TYP UNITS
ΘJA 20
°C/W
ΘJB
1
°C/W
NOTES
AC TEST CONDITIONS
Input pulse levels
Input rise and fall times
Input timing reference levels
Output reference levels
Output load
0V to 3.0V
1.5ns
1.5V
1.5V
See Figures 1 and
2
Notes:
1. All voltages referenced to VSS (GND).
2. Overshoot: VIH +3.6 V for t tKC/2.
Undershoot: VIL -1.0 V for t tKC/2.
3. Icc is given with no output current. Icc increases
with greater output loading and faster cycle
times.
4. This parameter is sampled.
5. Test conditions as specified with the output
loading as shown in Fig. 1 unless otherwise
noted.
6. Output loading is specified with CL = 5 pF as in
Fig. 2.
7. At any given temperature and voltage condition,
tKQHZ is less than tKQLZ and tOEHZ is less
than tOELZ.
8. A READ cycle is defined by byte write enables
all HIGH or ADSP LOW along with chip
enables being active for the required setup and
hold times. A WRITE cycle is defined by at one
byte or all byte WRITE per READ/WRITE
TRUTH TABLE.
9. OE is a "don't care" when a byte write enable
is sampled LOW.
10.This is a synchronous device. All synchronous
inputs must meet specified setup and hold time,
except for "don't care" as defined in the truth
table.
11.AC I/O curves are available upon request.
12."Device Deselected means the device is in
POWER-DOWN mode as defined in the truth
table. "Device Selected" means the device is
active.
13.Typical values are measured at 3.3V, 25°C and
20ns cycle time.
14.MODE pin has an internal pull-up and exhibits
an input leakage current of ± 10µA.
OUTPUT LOADS
Taiwan Memory Technology, Inc. reserves the right P.10
to change products or specifications without notice.
Publication Date: FEB. 2000
Revision:0.A

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]