STK402-100 Ver la hoja de datos (PDF) - SANYO -> Panasonic
Número de pieza
componentes Descripción
Fabricante
STK402-100 Datasheet PDF : 6 Pages
| |||
STK402-070
Thermal Design Example
The thermal resistance, θc-a of the required heat sink for the power dissipation, Pd, within the hybrid IC is determined as
follows.
Condition 1: The IC substrate temperature, Tc, must not exceed 125°C.
Pd × θc – a + Ta < 125°C . . . . . . . . . (1)
Ta: Guaranteed ambient temperature for the end product.
Condition 2: The junction temperature, Tj, of each power transistor must not exceed 150°C.
Pd × θc – a + Pd/N × θj – c + Ta < 150°C . . . . . . . . . (2)
N: Number of power transistors
θc-a: Thermal resistance per power transistor
However, the power dissipation, Pd, for the power transistors shall be allocated equally among the N transistors.
The following inequalities results from solving equations (1) and (2) for θc-a.
θc – a < (125 – Ta) /Pd . . . . . . . . . . . . . . . . . . (1)’
θc – a < (150 – Ta) /Pd – θj – c/N . . . . . . . . . (2)’
Values that satisfy these two inequalities at the same time represent the required heat sink thermal resistance.
When the following specifications have been stipulated, the required heat sink thermal resistance can be determined from
formulas (1)’ and (2)’.
• Supply voltage — VCC
• Load resistance value — RL
• Guaranteed ambient temperature — Ta
[Example]
When the IC supply voltage, VCC, is ±30 V and RL is 6 Ω, the IC internal power dissipation, Pd, will be a maximum of
63 W for a continuous sine wave signal at 1 kHz, according to the Pd – PO characteristics.
For the music signals normally handled by audio amplifiers, a value of 1/8 PO max is generally used for Pd as an estimate
of the power dissipation based on this type of continuous signal. (Note that the factor used may differ depending on the
safety standards used.)
That is:
Pd = 42 W (When 1/8 PO max = 5 W)
The number of power transistors in the audio amplifier block of these hybrid ICs, N, is 4, and the thermal resistance per
transistor is 3.2°C/W. Therefore, the required heat sink thermal resistance for a guaranteed ambient temperature of 50°C
will be as follows.
From formula (1)’
From formula (2)’
θc – a < (125 – 50) /42
< 1.78
θc – a < (150 – 50) /42 – 3.2/4
< 1.58
Therefore, 1.58°C/W is the required heat sink thermal resistance.
Note that this thermal design example assumes the use of a constant-voltage power supply, and is therefore not a verified
design for any particular user's end product.
No. 7047-4/6
Share Link: 