SP6121EB Ver la hoja de datos (PDF) - Signal Processing Technologies

Número de pieza

componentes Descripción

Fabricante

SP6121EB

Demo Board Manual

Signal Processing Technologies 

respectively), and the current set resistor (R2), are discussed in detail in the SP6121

data sheet.

USING THE DEMO BOARD

To use the Demo Board, connect the input voltage, VIN to pins 7 and 8 and a ground,

GND, to pins 5 and 6. Connect the load to pins 1, 2, 3, and 4. Pin 9 provides a logic

level “power good” signal and Pin 10 is used for trimming the output voltage.

When measuring efficiency, care must be taken to keep leads between measuring

devices, the power supply (VIN) and the demo board as short as possible and the

measurement probes should be connected to pins 4 (VOUT) and 7 (VIN).

The SP708 power management controller IC (U2) on the demo board is used to

generate a Power Good signal. On this demo board, when the voltage on the pin 6 (PFI)

of U2 is 1.25V or less, U2’s pin 7 (PFO) goes LOW. Pin 6 can be connected directly, or

through a resistor divider, to VOUT or VIN.

DEMO BOARD CHARACTERISTICS

96

94

92

90

88

86

84

82

80

78

0

1

2

3

4

5

6

I load (A)

FIGURE 4. EFFICIENCY vs. I load. Vout=2,5V

0.02

0

-0.02 3

4

5

6

-0.04

-0.06

-0.08

-0.1

-0.12

-0.14

Vin (V)

C6=47uF, 3.3/2.5V

C6=47uF,5.0/1.9V

C6=330uF,3.3/2.5V

C6=330uF,5.0/1.9V

7

8

9

10

I load=5.0A

I load=3.0A

FIGURE 5. Line Regulation. Vout=2.5V

Rev 7/25/01

4

Share Link: