Audio ICs
FCircuit operation
(1) About the data format
As shown in Fig. 2, there are 32 bits of data. When the
power is applied, a reset is applied to switch ports 1 to 4
off, but the reset is not applied to the other ports, so they
are unstable. For this reason, it is necessary to input the
data at least once while the set mute circuit is on.
BH3857AFV
∗ D18 : Surround matrix 1 control
D19 : Surround matrix 2 control
S Surround is on when the bit data is 0, and off when it
is 1.
S With regard to the port 1 to 4 outputs, when the power
is on, if no data is input the transistors for each output
are set to off. The outputs are on when the bit data is
1, and off when it is 0.
∗ Apply the following data for chip select and parity.
669