DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

SL6659 Ver la hoja de datos (PDF) - Zarlink Semiconductor Inc

Número de pieza
componentes Descripción
Fabricante
SL6659
ZARLINK
Zarlink Semiconductor Inc ZARLINK
SL6659 Datasheet PDF : 15 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
SL6659
ABSOLUTE MAXIMUM RATINGS
Supply voltage
Storage temperature
Mixer input
8V
255°C to 1150°C
1Vrms
NOTE: This device has static sensitive inputs, sensitivity
typically measured as 500V using MIL-STD-883 method
3015. Therefore, ESD handling precautions are essential to
avoid degradation of performance or permanent damage of
this device.
ELECTRICAL CHARACTERISTICS
The characteristics are guaranteed over the following condltions, unless otherwise stated:
VCC = 2·5V to 7·5V, TAMB = 230°C to 185°C, IF = 455kHz, RF = 50MHz, Quad Coil working Q = 30
Characteristic
Min.
Value
Typ.
Max.
Units
Conditions
Overall
Supply current
Sensitivity
AM rejection
VBIAS
Co-channel rejection
1·5
2·0
mA
20dB SINAD
5
µV
12dB SINAD
3
µV
RF input ,500µV
40
dB
TAMB = 25°C
1·0
1·2
1·4
V
See Note 2
7
dB
Mixer
RF input impedance
LO input impedance
LO input bias
Mixer gain
3rd order input intercept
LO input level
LO frequency
1
k
2
k
5
15
210
µA
dB
dBm
At VBIAS
RLOAD = 1.5k
180
300
mV
200
MHz
IF Amplifier
Gain
90
dB
Frequency
455
1500
kHz
Differential input impedance
20
k
Detector
Audio output level
Ultimate S/N ratio
THD
Output impedance
75
125
mV
60
dB
5mV into pin 13
0·5
5
%
40
k
RSSI Output (TAMB = 125°C)
Output current
25
µA
No input pin13
50
80
µA
Pin 13 = 2·5mV
Current change
0·9
1·22
1·5
µA/dB See Note 1
Linear dynamic range
70
dB
See Note 1
NOTES
1. The RSSI output is 100% dynamically tested at 5V and 120°C over a 70dB range. First the input to pin 13 is set to 2·5mV and the RSSI current
recorded. Then for each step of 10dB from 240 to 130db, the current is measured. The current change in each step must meet the specified
figure for current change. The RSSI output is guaranteed monotonic and free from discontinuities over this range.
2. Co-channel rejection is measured by applying a 3kHz deviation, 1kHz modulated signal at an input level to give a 20dB SINAD ratio. Then
a 3kHz deviation 400Hz modulated slgnal on the same frequency is also applied and its level increased to degrade the SINAD to 14dB.
2

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]