SI3015 Ver la hoja de datos (PDF) - Unspecified
Número de pieza
componentes Descripción
Fabricante
SI3015 Datasheet PDF : 54 Pages
| |||
Si3035
Table 3. DC Characteristics, VD = +5 V
(VA = +5 V ±5%, VD = +5 V ±5%, TA = 0 to 70°C for K-Grade)
Parameter
Symbol
Test Condition
Min
Typ
Max
High Level Input Voltage
VIH
3.5
—
—
Low Level Input Voltage
VIL
—
—
0.8
High Level Output Voltage
VOH
IO = –2 mA
3.5
—
—
Low Level Output Voltage
VOL
IO = 2 mA
—
—
0.4
Input Leakage Current
IL
–10
—
10
Power Supply Current, Analog
IA
VA pin
—
0.3
1
Power Supply Current, Digital1
ID
VD pin
—
14
18
Total Supply Current, Sleep Mode1
IA + ID
PDN = 1, PDL = 0
—
1.3
2.5
Total Supply Current, Deep Sleep1,2
IA + ID
PDN = 1, PDL = 1
—
0.04
0.5
Notes:
1. All inputs at 0.4 or VD – 0.4 (CMOS levels). All inputs held static except clock and all outputs unloaded
(Static IOUT = 0 mA).
2. RGDT is not functional in this state.
Unit
V
V
V
V
µA
mA
mA
mA
mA
Table 4. DC Characteristics, VD = +3.3 V
(VA = Charge Pump, VD = +3.3 V ± 0.3 V, TA = 0 to 70°C for K-Grade)
Parameter
Symbol
Test Condition
Min
Typ
Max
Unit
High Level Input Voltage
VIH
2.0
—
—
V
Low Level Input Voltage
VIL
—
—
0.8
V
High Level Output Voltage
VOH
IO = –2 mA
2.4
—
—
V
Low Level Output Voltage
VOL
IO = 2 mA
—
—
0.35
V
Input Leakage Current
IL
–10
—
10
µA
Power Supply Current, Analog1,2
IA
VA pin
—
0.3
1
mA
Power Supply Current, Digital3
ID
VD pin
—
9
12
mA
Total Supply Current, Sleep Mode3
IA + ID
PDN = 1, PDL = 0
—
1.2
2.5
mA
Total Supply Current, Deep Sleep3,4
IA + ID
PDN = 1, PDL = 1
—
0.04
0.5
Power Supply Voltage, Analog1,5
VA
Charge Pump On
4.3
4.6
5.00
V
Notes:
1. Only a decoupling capacitor should be connected to VA when the charge pump is on.
2. There is no IA current consumption when the internal charge pump is enabled and only a decoupling cap is connected
to the VA pin.
3. All inputs at 0.4 or VD – 0.4 (CMOS levels). All inputs held static except clock and all outputs unloaded
(Static IOUT = 0 mA).
4. RGDT is not functional in this state.
5. The charge pump is recommended to be used only when VD < 4.5 V. When the charge pump is not used, VA should be
applied to the device before VD is applied on power up if driven from separate supplies.
Rev. 1.2
5
Share Link: 