SA9607MSA Ver la hoja de datos (PDF) - South African Micro Electronic Systems

Número de pieza

componentes Descripción

Fabricante

SA9607MSA

Single Phase Power/Energy Metering IC with Tamper Detection

South African Micro Electronic Systems 

SA9607M

PIN DESCRIPTION

PIN Designation Description

20

GND

Analog Ground. The voltage to this pin should be mid-way between V and V .

DD

SS

8

VDD

Positive supply voltage. The voltage to this pin is typically +2.5V if a shunt resistor is used for current sensing

or in the case of a current transformer a +5V supply can be applied.

14

VSS

Negative Supply Voltage. The voltage to this pin is typicall -2.5V if a shunt resistor is used for current sensing

or in the case of a current transofer a 0V supply can be applied.

19

IVP

The current into the A/D converter should be set at 14µARMS at nominal mains voltage. The voltage sense

input saturates at an input current of ±25µA peak.

1, 2 IIN1, IIP1 Inputs for current sensor - channel 1 and Channel 2. The shunt resistor voltage from each channel is

3, 4 IIN2, IIP2 converted to a current of 16µARMS at rated conditions. The current sense input saturates at an input current

of ±25µA peak.

5

VREF This pin provides the connection for the reference current setting resistor. A 24kΩ resistor connected to VSS

set the optimum operating condition.

6, 7 MP0, MP1 Motor pulse rate select inputs. Described under Input Signals.

9, 12 MON, MOP Motor pulse outputs. These outputs can be used to drive an impulse counter or stepper motor directly.

13

LED Calibration LED output. Refer to section Led Output (LED) for the pulse rate output options.

15 RATED Rated condition select input. Described under Input Signals.

16

SEL1 Current channel select output. This output indicates which channel is been used for kWh metering.

17

ELT Earth loop tamper output. This output indicates an earth loop tamper condition.

18

DIRO Direction output. This output indicates the energy flow direction.

10, 11 OSC1, OSC2 Connections for a crystal or ceramic resonator. (OSC1 = input; OSC2 = Output)

IIN1 1

IIP1 2

IIN2 3

IIP2 4

VREF 5

MP1 6

MP0 7

VDD 8

MON 9

OSC1 10

D R -0 1557

20 GND

19 IV P

18 DIRO

17 ELT

16 SEL1

15 RAT ED

14 VSS

13 LED

12 MOP

11 O S C 2

Figure 2: Pin connections: Package: Dip-20, SOIC-20

ORDERING INFORMATION

Part Number

SA9607MPA

SA9607MSA

Package

DIP-20

SOIC-20

http://www.sames.co.za.

3/10

Share Link: