SA9605ASA Ver la hoja de datos (PDF) - South African Micro Electronic Systems

Número de pieza

componentes Descripción

Fabricante

SA9605ASA

THREE PHASE POWER/ENERGY METERING IC WITH INSTANTANEOUS PULSE OUTPUT

South African Micro Electronic Systems 

SA9605A

1. Power Calculation

In the Application Circuit (Figure 1), the mains voltages from Line 1, Line 2 and Line

3, are converted to currents and applied to the voltage sense inputs IVN1, IVN2 and

IVN3.

The current levels on the voltage sense inputs are derived from the mains voltage

(3 x 230 VAC) being divided down through voltage dividers to 14V. The resulting

input

currents

into

the

A/D

converters

are

14µA

through

the

resistors

R,

15

R

16

and

R.

17

For the current sense inputs the voltage drop across the current transformers

terminating resistors are converted to currents of 16µA for rated conditions, by

means of resistors R8, R9 (Phase 1); R10, R11 (Phase 2); and R12, R13 (Phase 3).

The signals providing the current information are applied to the current sensor

inputs: IIN1, IIP1; IIN2, IIP2; and IIN3, IIP3.

In this configuration, with the mains voltage of 3 x 230 V and rated currents of 80A,

the output frequency of the SA9605A energy metering integrated circuit at FOUT1

is 1.16kHz. In this case 1 pulse will correspond to an energy consumption of 3 x 18.4

kW/1160Hz = 47.6 Ws.

The output frequency at FOUT1 and FOUT2 represents the absolute sum of the

energy measured on all three phases, regardless of the direction of energy flow

through the current sensors. This measurement method will assist meter

manufacturers to circumvent meter tampering by reversal of the phases.

2. Analog Input Configuration

The current and voltage sensor inputs are illustrated below.

These inputs are protected against electrostatic discharge through clamping

diodes, in conjunction with the amplifiers input configuration.

The feedback loops from the outputs of the amplifiers A and A generate virtual

I

V

shorts on the signal inputs. Exact duplications of the input currents are generated

for the analog processing circuitry.

sames

5/14

Share Link: