S11155-2048 Ver la hoja de datos (PDF) - Hamamatsu Photonics
Número de pieza
componentes Descripción
Fabricante
S11155-2048 Datasheet PDF : 7 Pages
| |||
Driver circuit for CCD image sensor
C11165
Specifications (Typ. Ta=25 °C, unless otherwise noted)
Parameter
Scanning
Line readout time
Data transfer time
Total transfer time
A/D conversion resolution
Conversion gain
Readout noise
Dynamic range
Interface
Supply voltage
Dimension
Weight
Condition
65535ADU
Gain=1
950 mA typ.
Specification
6
377.5
344.67
722.17
16
3.6
12
5461
USB 2.0
DC + 4.5 to 5.5
80 (H) × 80 (W)
Approx. 65
Unit
MHz
μs
μs
μs
bit
e-/ADU
ADU
-
-
V
mm
g
Functions
Parameter
Suspend mode (LED-off)
Operating Standby mode (LED-white)
mode setting Data transfer mode
(LED-green, aqua, blue)
Internal synchronous mode
("INT" mode)
Selectable
data
acquisition
modes
External synchronous mode 1
("EXT.EDGE" mode)
External synchronous mode 2
("EXT.LEVEL" mode)
Gain adjustment
Offset adjustment
Pulse output signal setting
Specification
The power supply is turned off.
It is Standby state, in which the data acquisition is possible.
In this mode, the driver circuit sends the data to PC.
Data is acquired on the basis of the trigger timing generated by application software.
Data is acquired in synchronization with the external trigger signal input from the
BNC connector. In synchronization with an edge of the external trigger signal, data is
accumulated for the set integration time and is then output.
Data is acquired in synchronization with the external trigger signal input from the BNC
connector. Data is accumulated for a period equal to the pulse width of the external
trigger signal and is then output.
The gain value can be varied in the range of “1 to 10” with the step of 1. Default value is
"1".
The offset value can be varied in the range of “0 to 1020” with the step of 4. Default
value is "40".
It is possible to set the timing of the pulse output signal that is output from the “BNC
connector for pulse output” of the driver circuit.
2
Share Link: 