RC4152N Ver la hoja de datos (PDF) - Fairchild Semiconductor
Número de pieza
componentes Descripción
Fabricante
RC4152N Datasheet PDF : 12 Pages
| |||
PRODUCT SPECIFICATION
RC4152
The input waveform must have fast slewing edges, and the
differentiated input signal must be less than the timing
period of the one-shot, 1.1 ROCO. A differentiator and
divider are used to shape and bias the trigger input; a nega-
tive going pulse at pin 6 will cause the comparator to fire the
one-shot. The input pulse amplitude must be large enough to
trip the comparator, but not so large as to exceed the ICs
input voltage ratings.
The output voltage is directly proportional to the input
frequency:
VOUT =
1---.--1---R-----O---C----O----R----B----V----R----E---F-
RS
FIN(Hz)
Output ripple can be minimized by increasing CB, but this
will limit the response time. Recommended values for
various operating ranges are shown in the following table.
Precision FVC
Linearity, offset and response time can be improved by
adding one or more op amps to form an active lowpass filter
at the output. A circuit using a single pole active integrator is
shown in Figure 5.
The positive output current pulses are averaged by the invert-
ing integrator, causing the output voltage to be negative.
Response time can be further improved by adding a double
pole filter to replace the single pole filter. Refer to the graphs
under Typical Performance Characteristics that show
nonlinearity error versus input frequency for the
precision FVC circuit.
Input
Operating
Rage
0 to 1.0 kHz
CIN
0.02 mF
RO
CO
6.8 kW 0.1 mF
RB
CB Ripple
100 kW 100 mF 1.0 mV
0 to 10 kHz 0.002 mF 6.8 kW 0.01 mF 100 kW 10 mF 1.0 mV
0 to 100 kHz 200 pF 6.8 kW 0.001 mF 100 kW 1.0 mF 1.0 mV
+15V
10 k W
10Ÿ k W
RO
6.8 kW
CO
0.01 mF
C IN
0.022 mF
FIN
Frequency
Input
0 FIN 10kHz
7
VIN
6 VTH
+VS
5 kW 8
10 k W
+15V
RB
100K
4152
VFC
I OUT
1
5
CO Gnd 4
FOUT 3
RS
2
V OUT
CB
10 mF
R S = 16.7K
Figure 4. Single Supply FVC
4152-07
8
Share Link: 