PCF2119VU/2 Ver la hoja de datos (PDF) - NXP Semiconductors.

Número de pieza

componentes Descripción

Fabricante

PCF2119VU/2

LCD controllers/drivers

NXP Semiconductors. 

NXP Semiconductors

PCF2119x

LCD controllers/drivers

8. Functional description

8.1 Oscillator and timing generator

The internal logic and the LCD drive signals of the PCF2119x are timed by the frequency

fclk which equals either the built in oscillator frequency fosc or an external clock frequency

fclk(ext).

8.1.1 Timing generator

The timing generator produces the various signals required to drive the internal circuitry.

Internal chip operation is not disturbed by operations on the data buses.

8.1.2 Internal clock

To use the on-chip oscillator, pin OSC must be connected to VDD1. The on-chip oscillator

provides the clock signal for the display system. No external components are required.

8.1.3 External clock

If an external clock will be used, the input is at pin OSC. The resulting display frame

frequency is given by:

f fr

=

--f---o---s--c-

3072

(1)

Remark: Only in the power-down mode the clock is allowed to be stopped (pin OSC

connected to VSS), otherwise the LCD is frozen in a DC state, which is not suitable for the

liquid crystals.

8.2 Reset function and Power-On Reset (POR)

The PCF2119x must be reset externally when power is turned on. If no external reset is

performed, the chip might start-up in an unwanted state.

For the external reset, pin POR has to be active HIGH. The reset has to be active for at

least 3 oscillator periods in order for the reset to be executed. If the internal oscillator is

used, the minimum reset activity time follows from the lowest possible oscillator frequency

(fosc = 140 kHz, Tosc ~ 71 µs, 3 × Tosc ~ 215 µs). The internal oscillator start-up time is

200 µs (typ) up to 300 µs (max) after power-on. In case that an external oscillator is used,

Tosc is dependent from fosc(ext).

Afterwards the chip executes the Clear_display instruction, which requires 165 oscillator

cycles. After the reset the chip has the state shown in Table 4 and is then ready for use.

PCF2119X_5

Product data sheet

Rev. 05 — 13 August 2009

© NXP B.V. 2009. All rights reserved.

7 of 79

Share Link: