PCF85103C-2(2002) Ver la hoja de datos (PDF) - Philips Electronics

Número de pieza

componentes Descripción

Fabricante

PCF85103C-2
(Rev.:2002)

256 × 8-bit CMOS EEPROM with I2C-bus interface

Philips Electronics 

Philips Semiconductors

PCF85103C-2

256 × 8-bit CMOS EEPROM with I2C-bus interface

14. Soldering

14.1 Introduction

This text gives a very brief insight to a complex technology. A more in-depth account

of soldering ICs can be found in our Data Handbook IC26; Integrated Circuit

Packages (document order number 9398 652 90011).

There is no soldering method that is ideal for all IC packages. Wave soldering is often

preferred when through-hole and surface mount components are mixed on one

printed-circuit board. Wave soldering can still be used for certain surface mount ICs,

but it is not suitable for fine pitch SMDs. In these situations reflow soldering is

recommended.

14.2 Surface mount packages

14.2.1 Reflow soldering

Reflow soldering requires solder paste (a suspension of fine solder particles, flux and

binding agent) to be applied to the printed-circuit board by screen printing, stencilling

or pressure-syringe dispensing before package placement.

Several methods exist for reflowing; for example, convection or convection/infrared

heating in a conveyor type oven. Throughput times (preheating, soldering and

cooling) vary between 100 and 200 seconds depending on heating method.

Typical reflow peak temperatures range from 215 to 250 °C. The top-surface

temperature of the packages should preferable be kept below 220 °C for thick/large

packages, and below 235 °C for small/thin packages.

14.2.2 Wave soldering

Conventional single wave soldering is not recommended for surface mount devices

(SMDs) or printed-circuit boards with a high component density, as solder bridging

and non-wetting can present major problems.

To overcome these problems the double-wave soldering method was specifically

developed.

If wave soldering is used the following conditions must be observed for optimal

results:

• Use a double-wave soldering method comprising a turbulent wave with high

upward pressure followed by a smooth laminar wave.

• For packages with leads on two sides and a pitch (e):

– larger than or equal to 1.27 mm, the footprint longitudinal axis is preferred to be

parallel to the transport direction of the printed-circuit board;

– smaller than 1.27 mm, the footprint longitudinal axis must be parallel to the

transport direction of the printed-circuit board.

The footprint must incorporate solder thieves at the downstream end.

9397 750 09646

Product data

Rev. 02 — 09 May 2002

© Koninklijke Philips Electronics N.V. 2002. All rights reserved.

15 of 20

Share Link: