EM78P156E Ver la hoja de datos (PDF) - ELAN Microelectronics

Número de pieza

componentes Descripción

Fabricante

EM78P156E

8-bit CMOS microprocessor, 1K13-bit (OTP-ROM), 2.3V~5.5V

ELAN Microelectronics 

EM78P156E

Symbol

/RESET

P50~P53

P60~P67

/INT

VDD

V

SS

I/O

Function

I

* Input pin with Schmitt trigger. If this pin remains at logic low, the controller

will keep in reset condition.

I/O

* P50~P53 are bi-directional I/O pins. P50 and P51 can also be defined as the

R-option pins. P50~P52 can be pulled down by software .

I/O

* P60~P67 are bi-directional I/O pins. These can be pull-high or can be open-

drain by software programming. In addition, P60~P63 can be pull-down

also by software.

I

* External interrupt pin triggered by falling edge.

-

* Power supply.

-

* Ground.

VI. FUNCTION DESCRIPTION

VI.1 Operational Registers

1. R0 (Indirect Addressing Register)

• R0 is not a physically implemented register. Its major function is to be an indirect addressing pointer. Any instruction

using R0 as a pointer actually accesses data pointed by the RAM Select Register (R4).

2. R1 (Time Clock /Counter)

• Increased by an external signal edge which is defined by TE bit (CONT-4) through the TCC pin,

or by the instruction cycle clock.

• Writable and readable as any other registers.

3. R2 (Program Counter) & Stack

• R2 and hardware stacks are 10~12-bit wide. The structure is depicted in Fig. 3.

• Generating 1024x13 bits on-chip OTP ROM addresses to the relative programming instruction codes. One program

page is 1024 words long.

• The contents of R2 are set all “0”s upon a RESET condition.

• “JMP” instruction allows the direct loading of the lower 10 program counter bits. Thus, “JMP” allows PC to go to

any location within a page.

• “CALL” instruction loads the lower 10 bits of the PC, and then PC+1 is pushed into the stack. Thus, the subroutine

entry address can locate anywhere within a page.

“ RET” (“RETL K”, “RETI”) instruction loads the program counter with the contents of the top-level stack.

“ADD R2,A” allows a relative address to be added to the current PC, and the ninth and tenth bits of the PC are cleared.

• “MOV R2,A” allows to load an address from the “A” register to the lower 8 bits of the PC, and the ninth and tenth

bits of the PC are cleared.

• Any instruction which would change the contents of R2 (e.g. “ADD R2,A”, “MOV R2,A”, “BC R2,6”,......) will

cause the ninth and tenth bits (A8~A9) of the PC to be cleared. Thus, the computed jump is limited to the first

256 locations of a page.

• All instructions are single instruction cycle (fclk/2) except the instructions which would change the contents of R2

need one more instruction cycle.

* This specification is subject to be changed without notice. 8.11.1999

B3-3

Share Link: