R1280A Ver la hoja de datos (PDF) - HP => Agilent Technologies

Número de pieza

componentes Descripción

Fabricante

R1280A

67 GHz Single-Mode Lightwave Component Analyzer for 40/100G electro-optical test

HP => Agilent Technologies 

Measurement capabilities

3dB cut-off frequency (S21),

Responsivity (S21),

Electrical reflection (S11 or S22),

Group Delay vs. frequency,

Insertion Loss (IL),

Transmission bandwidth,

all electrical S-parameter measurements.

Target test devices

Transmitter (E/O)

‡ 0DFK=HKQGHUPRGXODWRUV

‡ (OHFWURDEVRUSWLRQPRGXODWRUV($0

‡ 'LUHFWO\PRGXODWHGODVHUV

‡ 7UDQVPLWWHURSWLFDOVXEDVVHPEOLHV726$

Receiver (O/E)

‡ PIN diodes

‡ Avalanche photodiodes (APD)

‡ Receiver optical subassemblies (ROSA)

Optical (O/O)

‡ Passive optical components

‡ Optical fibers and filters

‡ Optical transmission systems

Agilent N4373C Specifications

Measurement conditions

‡ Network analyzer set to -8 dBm electrical output

power

‡ Modulation frequency range from 10 MHz to 65 GHz

‡ Number of averages: 1

‡ 100 Hz IFBW (“Reduce IF bandwidth at low frequency”

enabled) with modulation frequency step size 10 MHz

and measurement points on a 10 MHz raster (if not

differently stated).

‡ Network analyzer set to “stepped sweep” – sweep

moves in discrete steps”

‡ Port 2 of network analyzer configured in reverse

coupler configuration (“RCVB B in” to “CPLR THRU”,

“SOURCE OUT” to “CPLR ARM”)

‡ After full two-port electrical calibration using an Elec-

tronic Calibration Module, Agilent N4694A, at constant

temperature (±1° C).

‡ Modulation-bias optimization set to “every sweep”

‡ Using the supplied flexible test port cables 1.85mm f m

(Part Number N4697-60200).

‡ Measurement frequency grid equals electrical calibra-

tion grid.

‡ Tested from Port 1 to Port 2.

‡ DUT signal delay ≤ 0.1/IF-BW.

‡ Specified temperature range: +20° C to +26° C.

‡ After warm-up time of 90 minutes.

‡ Using high quality electrical and optical connectors in

perfect condition.

‡ Using internal laser source.

6

Share Link: