SPC5566MVR112 Ver la hoja de datos (PDF) - Freescale Semiconductor

Número de pieza

componentes Descripción

Fabricante

SPC5566MVR112

Microcontroller

Freescale Semiconductor 

Electrical Characteristics

The thermal characterization parameter is measured in compliance with the JESD51-2 specification using

a 40-gauge type T thermocouple epoxied to the top center of the package case. Position the thermocouple

so that the thermocouple junction rests on the package. Place a small amount of epoxy on the thermocouple

junction and approximately 1 mm of wire extending from the junction. Place the thermocouple wire flat

against the package case to avoid measurement errors caused by the cooling effects of the thermocouple

wire.

References:

Semiconductor Equipment and Materials International

3081 Zanker Rd.

San Jose, CA., 95134

(408) 943-6900

MIL-SPEC and EIA/JESD (JEDEC) specifications are available from Global Engineering Documents at

800-854-7179 or 303-397-7956.

JEDEC specifications are available on the web at http://www.jedec.org.

1. C.E. Triplett and B. Joiner, “An Experimental Characterization of a 272 PBGA Within an Automotive

Engine Controller Module,” Proceedings of SemiTherm, San Diego, 1998, pp. 47–54.

2. G. Kromann, S. Shidore, and S. Addison, “Thermal Modeling of a PBGA for Air-Cooled Applica-

tions,” Electronic Packaging and Production, pp. 53–58, March 1998.

3. B. Joiner and V. Adams, “Measurement and Simulation of Junction to Board Thermal Resistance and

Its Application in Thermal Modeling,” Proceedings of SemiTherm, San Diego, 1999, pp. 212–220.

3.3 Package

The MPC5566 is available in packaged form. Read the package options in Section 2, “Ordering

Information.” Refer to Section 4, “Mechanicals,” for pinouts and package drawings.

3.4 EMI (Electromagnetic Interference) Characteristics

Table 4. EMI Testing Specifications 1

Spec

Characteristic

Minimum

Typical

Maximum

Unit

1 Scan range

0.15

—

1000

MHz

2 Operating frequency

—

—

fMAX

MHz

3 VDD operating voltages

—

1.5

—

V

4 VDDSYN, VRC33, VDD33, VFLASH, VDDE operating voltages

—

3.3

—

V

5 VPP, VDDEH, VDDA operating voltages

6 Maximum amplitude

—

5.0

—

V

—

—

14 2

dBuV

32 3

7 Operating temperature

—

—

25

oC

1 EMI testing and I/O port waveforms per SAE J1752/3 issued 1995-03. Qualification testing was performed on the MPC5554

and applied to the MPC5500 family as generic EMI performance data.

2 Measured with the single-chip EMI program.

3 Measured with the expanded EMI program.

MPC5566 Microcontroller Data Sheet, Rev. 3

8

Freescale Semiconductor

Share Link: