ML4435CP Ver la hoja de datos (PDF) - Micro Linear Corporation
Número de pieza
componentes Descripción
Fabricante
ML4435CP Datasheet PDF : 14 Pages
| |||
PRELIMINARY
ML4435
FUNCTIONAL DESCRIPTION
times the commutation frequency. The TACH out also
indicates a low motor speed by staying TTL high when the
motor is at its minimum speed (SPEED FB below 0.97V).
BACK EMF SAMPLER
The input to the VCO (pin 18) SPEED FB is controlled by
the Back EMF Sampler. The back EMF sense pins FB A,
FB B, and FB C inputs to the back EMF sampler require
a signal from the motor phase leads that is below the
VCC of the ML4435. The phase sense input impedance is
8.7kΩ. If the motor voltage is greater than the VCC of the
ML4435 then this requires a series resistor RFB from the
motor phase lead shown in Figure 8. RFB can be selected
by using the graph in Figure 9 or using the following
equation:
RFB = 8.7kW ( VMOTOR - 1)
12
BLDC
MOTOR
RFBA
RFBB
RFBC
4 FBA
5 FBB
6 FBC
ABC
Figure 8. Back EMF Sampler Configuration
The back EMF sampler takes the motor phase voltages
divided down to signals that are less than VCC (12V
nominal) and calculates the neutral point of the motor by
the following equation:
VNEUTRAL = (FB A + FB B + FB C)/3
This allows the ML4435 to compare the back EMF signal
to the motors neutral point without the need for bringing
out an extra wire on a WYE wound motor. For DELTA
wound motors there isn’t a physical neutral to bring out so
this reference point must be calculated anyway.
The back EMF sampler takes the motor phase that is not
driven (i.e. if LA and HB are on then phase A is driven
low and phase B is driven high then phase C is sampled).
The sampled phase provides a back EMF signal that is
compared against the neutral of the motor. The sampler
is controlled by the commutation state machine. The
sampled back EMF is compared to the neutral through an
error amplifier. The output of the error amplifier outputs
a charging or discharging current to SPEED FB (pin 18)
which provides the voltage to the VCO.
BACK EMF SENSING PHASE LOCKED LOOP
COMMUTATION CONTROL
The three blocks: The commutation state machine, the
VCO, and the back EMF sampler form a phase locked
loop that locks the commutation clock onto the back EMF
signal. The complete phase locked loop is illustrated in
Figure 10. The phased locked loop requires a lead lag
filter that is set by external components on SPEED FB (pin
18). The filter components in Figure 10 work for most
applications. If performance is unstable C1 and C2 can
go up or down a decade in value as low as the C2 stays
equal to C1 x 10.
2,000
0,000
,000
6,000
4,000
2,000
0
0
5
20
25
30
Motor Volta e [Max] V
Figure 9. RFB vs. VMOTOR [MAX]
FBA
4
FBB
5
FBC
6
BACK EMF
SAMPLER
SPEED FB
CSFB
VCO
COMMUTATION
STATE MACHINE
RSFB
RSFB2
CSFB2
Figure 10. Phase Locked Loop
8
PRELIMINARY DATASHEET May, 2000
Share Link: 