MICRF102 Ver la hoja de datos (PDF) - Micrel

Número de pieza

componentes Descripción

Fabricante

MICRF102

QwikRadio™ UHF ASK Transmitter

Micrel 

MICRF102

Pin Configuration

PC 1

VDD 2

VSS 3

REFOSC 4

8 ASK

7 ANTP

6 ANTN

5 STBY

8-Pin SOIC (M)

Micrel

Pin Description

Pin Number

1

2

3

4

5

6

7

8

Pin Name

PC

VDD

VSS

REFOSC

STBY

ANTN

ANTP

ASK

Pin Function

Power Control Input. The voltage at this pin should be set between 0.15V to

0.35V for normal operation.

Positive power supply input for the IC. This pin requires a large capacitor for

ripple decoupling. A 4.7µF is recommended.

This pin is the ground return for the IC. A power supply bypass capacitor

connected from VDD to VSS should have the shortest possible path.

This is the timing reference frequency which is the transmit frequency di-

vided by 32. Connect a crystal (mode dependent) between this pin and VSS,

or drive the input with an AC-coupled 0.5VPP input clock. See “Reference

Oscillator” section in this data sheet. The crystal needs to have a 10pF load

capacitance.

Input for transmitter stand by control pin is pulled to VDD for transmit opera-

tion and VSS for stand-by mode. The device requires 0.0 volts to be placed

in stand by.

Negative RF power output to drive the low side of the transmit loop antenna.

The RF output stage is tuned in the data transitions in the ASK pin.

Positive RF power output to drive the high side of the transmit loop antenna.

The RF output stage is tuned in the data transitions in the ASK pin.

Amplitude Shift Key modulation data input pin. For CW operation, connect

this pin to VDD. Several transitions of highs and lows are required to tune the

output RF stages.

MICRF102

2

December 2006

Share Link: