56F8167 Ver la hoja de datos (PDF) - Freescale Semiconductor

Número de pieza

componentes Descripción

Fabricante

56F8167

56F8322 16-bit Hybrid Controller

Freescale Semiconductor 

Version History

Rev 0

Rev 1.0

Rev 2.0

Rev 3.0

Rev 4.0

Rev 5.0

Rev 6.0

Rev 7.0

Rev. 8

Rev. 9

Document Revision History

Description of Change

Pre-release, Alpha customers only

Initial Public Release

Added output voltage maximum value and note to clarify in Table 10-1.; also removed

overall life expectancy note, since life expectancy is dependent on customer usage and

must be determined by reliability engineering. Clarified value and unit measure for

Maximum allowed PD in Table 10-3. Corrected note about average value for Flash Data

Retention in Table 10-4. Added new RoHS-compliant orderable part numbers in

Table 13-1.

Added 160MAPBGA information, TA equation updated in Table 10-4 and additional minor

edits throughout data sheet

Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient

Operating Temperature (Industrial) and corrected Flash Endurance to 10,000 in

Table 10-4. Added RoHS-compliance and “pb-free” language to back cover.

Correcting MBGA pin assignments in Table 2-2 for MOSI0 and MISO0

Added information/corrected state during reset in Table 2-2. Clarified external reference

crystal frequency for PLL in Table 10-14 by increasing maximum value to 8.4MHz.

Corrected CLKO and HOME1 labels in Figure 11-2 and Table 11-2; replaced “Tri-stated”

with an explanation in State During Reset column in Table 2-2.

• Added the following note to the description of the TMS signal in Table 2-2:

Note: Always tie the TMS pin to VDD through a 2.2K resistor.

• Added the following note to the description of the TRST signal in Table 2-2:

Note: For normal operation, connect TRST directly to VSS. If the design is to be used in a

debugging environment, TRST may be tied to VSS through a 1K resistor.

• Add Figure 10-1 showing current voltage characteristics.

• In Table 10-24, correct interpretation of Calibration Factors to be viewed as worst case

factors.

Please see http://www.freescale.com for the most current data sheet revision.

56F8367 Technical Data, Rev. 9

2

Freescale Semiconductor

Preliminary

Share Link: