MB95110M Ver la hoja de datos (PDF) - Fujitsu

Número de pieza

componentes Descripción

Fabricante

MB95110M

8-bit Microcontrollers

Fujitsu 

MB95110M Series

(Continued)

Part number

Parameter

MB95117M

MB95F114MS/ MB95F114NS/ MB95F114MW/ MB95F114NW/ MB95F114JS/ MB95F114JW/

MB95F116MS/ MB95F116NS/ MB95F116MW/ MB95F116NW/ MB95F116JS/ MB95F116JW/

MB95F118MS MB95F118NS MB95F118MW/ MB95F118NW MB95F118JS MB95F118JW

LIN-UART

(1 channel)

Dedicated reload timer allowing a wide range of communication speeds to be set.

Full duplex double buffer.

Clock asynchronous (UART) or clock synchronous (SIO) serial data transfer

capable.

LIN functions available as the LIN master or LIN slave.

8/10-bit A/D

converter

(8 channels)

8-bit or 10-bit resolution can be selected.

8/16-bit

compound

timer

(2 channels)

Each channel of the timer can be used as “8-bit timer × 2 channels” or

“16-bit timer × 1 channel”.

Built-in timer function, PWC function, PWM function, capture function, and square waveform

output

Count clock : 7 internal clocks and external clock can be selected

16-bit PPG

(1 channel)

8/16-bit PPG

(2 channels)

PWM mode or one-shot mode can be selected.

Counter operating clock : 8 selectable clock sources

Support for external trigger start

Each channel of the PPG can be used as “8-bit PPG × 2 channels” or “16-bit PPG × 1 channel”.

Counter operating clock : Eight selectable clock sources

Watch counter Count clock : 4 selectable clock sources (125 ms, 250 ms, 500 ms, or 1 s)

(for dual clock Counter value can be set from 0 to 63 (Capable of counting for 1minute when

product)

selecting clock source 1 second and setting counter value to 60).

Watch

prescaler

(for dual clock 4 selectable interval times (125 ms, 250 ms, 500 ms, or 1 s)

product)

(1 channel)

External

interrupt

(8 channels)

Interrupt by edge detection (rising, falling, or both edges can be selected.)

Can be used to recover from standby modes.

Flash memory

Supports automatic programming, Embedded Algorithm

Write/Erase/Erase-Suspend/Resume commands

A flag indicating completion of the algorithm

Number of write/erase cycles (Minimum) : 10000 times

Data retention time: 20 years

Erase can be performed on each block

Block protection with external programming voltage

Dual operation Flash memory

Flash Security Feature for protecting the content of the Flash

Standby mode Sleep, stop, watch (for dual clock product) , and time-base timer

*1 : For ROM capacitance and RAM capacitance, refer to “■ MEMORY LINEUP”.

*2 : When the MASK ROM is ordered, please select yes/no for the clock mode, low voltage detection, clock

supervisor and reset output.

*3 : Specify clock mode when ordering MASK ROM.

Note : Part number of the evaluation products in MB95110M series is MB95FV100D-103. When using it, the MCU

board (MB2146-303A) is required.

5

Share Link: