M28W160C-ZBS Ver la hoja de datos (PDF) - Numonyx -> Micron

Número de pieza

componentes Descripción

Fabricante

M28W160C-ZBS

16 Mbit (1Mb x16, Boot Block) 3V Supply Flash Memory

Numonyx -> Micron 

M28W160CT, M28W160CB

SUMMARY DESCRIPTION

The M28W160C is a 16 Mbit (1 Mbit x 16) non-vol-

atile Flash memory that can be erased electrically

at the block level and programmed in-system on a

Word-by-Word basis. These operations can be

performed using a single low voltage (2.7 to 3.6V)

supply. VDDQ allows to drive the I/O pin down to

1.65V. An optional 12V VPP power supply is pro-

vided to speed up customer programming.

The device features an asymmetrical blocked ar-

chitecture. The M28W160C has an array of 39

blocks: 8 Parameter Blocks of 4 KWord and 31

Main Blocks of 32 KWord. M28W160CT has the

Parameter Blocks at the top of the memory ad-

dress space while the M28W160CB locates the

Parameter Blocks starting from the bottom. The

memory maps are shown in Figure 5, Block Ad-

dresses.

The M28W160C features an instant, individual

block locking scheme that allows any block to be

locked or unlocked with no latency, enabling in-

stant code and data protection. All blocks have

three levels of protection. They can be locked and

locked-down individually preventing any acciden-

tal programming or erasure. There is an additional

hardware protection against program and erase.

When VPP ≤VPPLK all blocks are protected against

program or erase. All blocks are locked at power-

up.

Each block can be erased separately. Erase can

be suspended in order to perform either read or

program in any other block and then resumed.

Program can be suspended to read data in any

other block and then resumed. Each block can be

programmed and erased over 100,000 cycles.

The device includes a 128 bit Protection Register

and a Security Block to increase the protection of

a system design. The Protection Register is divid-

ed into two 64 bit segments, the first one contains

a unique device number written by Numonyx,

while the second one is one-time-programmable

by the user. The user programmable segment can

be permanently protected. The Security Block, pa-

rameter block 0, can be permanently protected by

the user. Figure 6, shows the Security Block and

Protection Register Memory Map.

Program and Erase commands are written to the

Command Interface of the memory. An on-chip

Program/Erase Controller takes care of the tim-

ings necessary for program and erase operations.

The end of a program or erase operation can be

detected and any error conditions identified. The

command set required to control the memory is

consistent with JEDEC standards.

The memory is offered in TSOP48 (10 X 20mm)

and TFBGA46 (6.39 x 6.37mm, 0.75mm pitch)

packages and is supplied with all the bits erased

(set to ’1’).

In order to meet environmental requirements, Nu-

monyx offers the M28W160C in ECOPACK®

packages.

ECOPACK packages are Lead-free. The category

of second Level Interconnect is marked on the

package and on the inner box label, in compliance

with JEDEC Standard JESD97. The maximum rat-

ings related to soldering conditions are also

marked on the inner box label.

5/50

Share Link: