LTC1657 Ver la hoja de datos (PDF) - Linear Technology

Número de pieza

componentes Descripción

Fabricante

LTC1657

Parallel 16-Bit Rail-to-Rail Micropower DAC

Linear Technology 

LTC1657/LTC1657L

TYPICAL PERFOR A CE CHARACTERISTICS

LTC1657 0.1Hz to 10Hz

Voltage Noise

LTC1657L 0.1Hz to 10Hz

Voltage Noise

0 1 2 3 4 5 6 7 8 9 10

TIME (SEC)

1659 G19

0 1 2 3 4 5 6 7 8 9 10

TIME (SEC)

1659 G20

PI FU CTIO S

WR (Pin 1): Write Input (Active Low). Used with CSMSB

and/or CSLSB to control the input registers. While WR and

CSMSB and/or CSLSB are held low, data writes into the

input register.

CSLSB (Pin 2): Chip Select Least Significant Byte (Active

Low). Used with WR to control the LSB 8-bit input regis-

ters. While WR and CSLSB are held low, the LSB byte

writes into the LSB input register. Can be connected to

CSMSB for simultaneous loading of both sets of input

latches on a 16-bit bus.

CSMSB (Pin 3): Chip Select Most Significant Byte (Active

Low). Used with WR to control the MSB 8-bit input

registers. While WR and CSMSB are held low, the MSB

byte writes into the MSB input register. Can be connected

to CSLSB for simultaneous loading of both sets of input

latches on a 16-bit bus.

D0 to D7 (Pins 4 to 11): Input data for the Least Significant

Byte. Written into LSB input register when WR = 0 and

CSLSB = 0.

D8 to D15 (Pins 12 to 19): Input data for the Most Signifi-

cant Byte. Written into MSB input register when WR = 0

and CSMSB = 0.

GND (Pin 20): Ground.

REFLO (Pin 21): Lower input terminal of the DAC’s inter-

nal resistor ladder. Typically connected to Analog Ground.

An input code of (0000)H will connect the positive input of

the output buffer to this end of the ladder. Can be used to

offset the zero scale above ground.

REFHI (Pin 22): Upper input terminal of the DAC’s internal

resistor ladder. Typically connected to REFOUT. An input

code of (FFFF)H will connect the positive input of the

output buffer to 1LSB below this voltage.

REFOUT (Pin 23): Output of the internal reference is

2.048V (LTC1657), 1.25V (LTC1657L). Typically con-

nected to REFHI to drive internal DAC resistor ladder.

VCC (Pin 24): Positive Power Supply Input. 4.5V ≤ VCC ≤

5.5V (LTC1657), 2.7V ≤ VCC ≤ 5.5V (LTC1657L). Requires

a 0.1µF bypass capacitor to ground.

VOUT (Pin 25): Buffered DAC Output.

X1/X2 (Pin 26): Gain Setting Resistor Pin. Connect to GND

for G = 2 or to VOUT for G = 1. This pin should always be

tied to a low impedance source, such as ground or VOUT,

to ensure stability of the output buffer when driving

capacitive loads.

7

Share Link: