LC750 Ver la hoja de datos (PDF) - Unspecified
Número de pieza
componentes Descripción
Fabricante
LC750 Datasheet PDF : 10 Pages
| |||
Patient Care Unit with Standard Laminate or Optional Terreon® Top
LC700, LC750
Installation Instructions
Patient Care Unit Cleaning and Maintenance
Regular cleaning greatly prolongs the service life of Terreon®, stainless steel and laminate fixtures and, at
the same time, helps to maintain a pleasing surface appearance. The amount and frequency of cleaning
depends on the service conditions involved. For best results, fixtures should be cleaned as often as films or
deposits become apparent. This will remove built-up deposits which may eventually cause concentration
cells to set on the surface.
CAUTION: USING CLEANERS THAT CONTAIN HARSH CHEMICALS, ABRASIVES, ACIDS
OR DISINFECTANTS, OR CLEANING WITH STEEL WOOL OR BRUSHES, WILL RESULT IN
DAMAGE TO ALL SURFACES. IF THESE CHEMICALS COME IN CONTACT WITH ANY
SURFACE, WIPE OFF THE SURFACE IMMEDIATELY AND FLUSH WITH SOAPY WATER.
ALWAYS READ THE LABEL ON ANY CLEANING PRODUCT BEFORE APPLYING TO ANY
FIXTURE.
Terreon® cleaning
• Daily cleaning: Wipe the Terreon® with a wet cloth, then rinse with clear water and wipe dry.
• Weekly cleaning: Give the Terreon® surface a thorough cleaning with a damp cloth and a
household liquid detergent or ammonia-based cleaner. Most stains can be removed by cleaning the
Terreon® surface with a mild abrasive cleaner, then rinsing and allowing to dry. Stubborn stains
can be cleaned as follows:
1. using a #7448 Scotch-Briteâ„¢ pad, scrub with an abrasive cleanser and water
2. clean thoroughly with clean soap and water and allow to dry
• Scorch marks: Although Terreon® will not burn, a lit cigarette in contact with the Terreon®
material could leave a scorch mark. Scorch marks can be removed with either an abrasive cleaner
or by buffing with a #7448 Scotch-Briteâ„¢ pad.
• Repair kit: A repair kit is available from Bradley to repair/patch Terreon®. Contact your Modular
Services representative to order a repair kit and be sure to specify color when ordering.
Stainless steel and laminate cleaning
• Give the laminate surface a thorough cleaning with a non-abrasive liquid tub-and-tile cleaner to
remove soil and maintain the glossy finish.
You may safely use the following cleaners:
Formula 409®
Soft Scrub®
Spic and Span® Powder
Windex®
Liquid Comet®
Glass Plus®
Mr. Clean®
DO NOT use the following:
Whitecap®
Lysol® Disinfectant Spray Lestoil®
Pinesol®
Dow® Disinfectant Bathroom Cleaner
acetone, alcohol or steel wool/brushes
• Remove all material and deposits that tend to adhere to the laminate surface, taking special note of
crevices and corners
• Remove all material and deposits that tend to adhere to the stainless steel surface with stainless
steel polishing powder (always rub in the direction of the polishing lines)
• Check for rust spots or streaks on the stainless steel surface and look for the source of the rust (a
steel nail located in some iron or steel not actually a part of the stainless steel fixture may be the
cause). Rinse the laminate and stainless steel surfaces thoroughly and dry completely after
washing.
10
8/16/04
Bradley Corporation • 215-1171 Rev. D; EN 04-1037
Share Link: 