LC03-6.TB Ver la hoja de datos (PDF) - Semtech Corporation
Número de pieza
componentes Descripción
Fabricante
LC03-6.TB Datasheet PDF : 11 Pages
| |||
LC03-6
PROTECTION PRODUCTS
Applications Information
Device Connection Options for Protection of Two
High-Speed Data Lines
The LC03-6 is designed to protect two high-speed data
lines (one differential pair) from transient over-voltages
which result from lightning and ESD. The device can be
configured to protect in differential (Line-to-Line) and
common (Line-to-Ground) mode. Data line inputs/
outputs are connected at pins 1 to 8, and 4 to 5 as
shown. Pins 2, 3, 6, and 7 are connected to ground.
These pins should be connected directly to a ground
plane on the board for best results. The path length is
kept as short as possible to minimize parasitic induc-
tance. In applications where high common mode
voltages are present, differential protection is achieved
by leaving pins 2, 3, 6, and 7 not connected.
Connection for Differential (Line-to-Line) and
Common Mode Protection (Line-to-Ground)
Connection for Differential Protection
(Line-to-Line)
T1/E1 Linecard Protection (Intra-Building)
A typical T1/E1 linecard protection circuit is shown
below. The LC03-6 is connected between Tip and Ring
on the transmit and receive line pairs. It provides
protection to metallic and common mode lightning
surges per Bellcore 1089. This design takes advan-
tage of the isolation of the transformer to suppress
common mode surges. To complete the protection
circuit, the RClamp3304N (or RClamp0504N for 5V
supplies) is employed as the IC side protection ele-
ment. This device helps prevent the transceiver from
latching up by providing fine clamping of transients that
are coupled through the transformer. For further
information, reference Semtech application note
AN97-10.
T3/E3 and STS-1 Protection
The LC03-6 can also be used to protect T3/E3 and
STS-1 interfaces. The data lines from the BNC inter-
face are run through the LC03-6 (i.e. enters at pin 1
and exits at pin 8) with the ground connection made at
the other side of the device (pins 4 and 5). The center
pins (2, 3, 6, and 7) are not connected. In this configu-
ration, the LC03-6 adds less than 12pF of capacitance
to each line and provides surge protection to 100A
(tp=8/20µs).
Matte Tin Lead Finish
Matte tin has become the industry standard lead-free
replacement for SnPb lead finishes. A matte tin finish
is composed of 100% tin solder with large grains.
Since the solder volume on the leads is small com-
pared to the solder paste volume that is placed on the
land pattern of the PCB, the reflow profile will be
determined by the requirements of the solder paste.
Therefore, these devices are compatible with both
lead-free and SnPb assembly techniques. In addition,
unlike other lead-free compositions, matte tin does not
have any added alloys that can cause degradation of
the solder joint.
2008 Semtech Corp.
5
www.semtech.com
Share Link: 