EL2141 Ver la hoja de datos (PDF) - Intersil
Número de pieza
componentes Descripción
Fabricante
EL2141 Datasheet PDF : 6 Pages
| |||
EL2141
Absolute Maximum Ratings (TA = 25°C)
Supply Voltage VS+ and GND . . . . . . . . . . . . . . . . . . . . . . . . +12.6V
Maximum Output Current. . . . . . . . . . . . . . . . . . . . . . . . . . . . ±60mA
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +150°C
Recommended Operating Temperature . . . . . . . . . . . -40°C to 85°C
VIN, VINB, VREF. . . . . . . . . . . . VEE+0.8V (MIN) to VCC-0.8V (MAX)
VIN–VINB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±5V
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA
DC Electrical Specifications VCC = +5V, VEE = -5V, TA = 25°C, VIN = 0V, RL = 200, unless otherwise specified.
PARAMETER
DESCRIPTION
MIN
TYP
MAX
VSUPPLY
IS
VOS
IIN
ZIN
VDIFF
AVOL
VOUT(200)
VOUT(100)
VN
VREFOS
PSRR
Supply Operating Range (VCC–VEE)
Power Supply Current (No Load)
Input Referred Offset Voltage
Input Bias Current (VIN, VINB, VREF)
Differential Input Impedance
Differential Input Range
Open Loop Voltage Gain
Output Voltage Swing (200Ω load, VOUT to VOUTB)
Output Voltage Swing (100Ω Load, VOUT to VOUTB)
Input Referred Voltage Noise
Output Offset Relative to VREF
Power Supply Rejection Ratio
±3.0
±5.0
±6.3
11
14
-25
10
40
-20
6
20
400
±2.0
±2.3
75
±3.4
±3.6
±2.9
±3.1
36
-60
-25
+60
60
70
IOUT(min)
ROUT
Minimum Output Current
(VOUT = VOUTB = 0V) Output Impedance
50
60
0.1
UNITS
V
mA
mV
µA
kΩ
V
dB
V
V
nV/√Hz
mV
dB
mA
Ω
AC Electrical Specifications VCC = +5V, VEE = -5V, TA = 25°C, VIN = 0V, RLOAD = 200, unless otherwise specified
PARAMETER
DESCRIPTION
MIN
TYP
MAX
BW(-3dB)
-3dB Bandwidth (@ gain of 2)
150
SR
Differential Slewrate
800
Tstl
Settling Time to 1%
15
GBW
Gain Bandwidth Product
400
VREFBW(-3dB) VREF -3dB Bandwidth
130
VREFSR
VREF Slewrate
100
THDf1
Distortion at 100kHz (Note 1)
-75
dP
Differential Phase @ 3.58MHz
0.16
dG
Differential Gain @ 3.58MHz
0.24
NOTE:
1. Distortion measurement quoted for VOUT–VOUTB = 12V pk-pk, RLOAD = 200Ω, VGAIN = 8
UNITS
MHz
V/µs
ns
MHz
MHz
V/µs
dB
°
%
2
FN7048.1
February 11, 2005
Share Link: 