EKM6211 Ver la hoja de datos (PDF) - ELAN Microelectronics

Número de pieza

componentes Descripción

Fabricante

EKM6211

RF Mouse Rx Controller

ELAN Microelectronics 

eKM6211

RF Mouse Rx Controller

6.1.5.2 Resend (FE)

A Any time eKM6211 receives an invalid command, it returns a Resend command to

the system.

B When eKM6211 receives a Resend command, it retransmits its last packet of data.

If the last packet was a Resend command, it transmits the packet just prior to the

Resend command.

C In stream mode, if a Resend command is received by eKM6211 immediately

following a 3-byte data packet transmission to the system.

6.1.5.3 Set Default (F6)

The command reinitializes all conditions to the power-on defaults.

6.1.5.4 Disable (F5)

This command is used in the stream mode to stop transmissions from eKM6211.

6.1.5.5 Enable (F4)

Begins transmissions, if in stream mode.

6.1.5.6 Set Sampling Rate (F3, XX)

In the stream mode, this command set the sampling rate to the value indicated by byte

hex XX, shown in following:

Second byte XX

Sample Rate

0A

10/sec

14

20/sec

28

40/sec

3c

60/sec

50

80/sec

64

100/sec

C9

200/sec

6.1.5.7 Read Device Type (F2)

eKM6211 always echoes " FA, 00" following this command.

6.1.5.8 Set Remote Mode (F0)

Data values are reported only in response to a Read Data command.

6.1.5.9 Set Wrap Mode (EE)

Wrap mode remains until Reset (FF) or Reset Wrap Mode (EC) is received.

6.1.5.10 Reset Wrap Mode (EC)

eKM6211 returns to the previous mode of operation after receiving this command.

Product Specification (V1.0) 11.15.2003

•7

(This specification is subject to change without further notice)

Share Link: