CMX860 Ver la hoja de datos (PDF) - CML Microsystems Plc

Número de pieza

componentes Descripción

Fabricante

CMX860

Telephone Signalling Transceiver

CML Microsystems Plc 

Telephone Signalling Transceiver / Least Cost Router

CMX860

1.5.6 DTMF Decoder and Tone Detectors

In Rx Tones Detect mode the received signal, after passing through the Rx Gain Control block, is fed to

the DTMF decoder and Dual Tone/Call Progress/Answer Tone detector. The user may select one of four

separate operations:

The DTMF decoder detects standard DTMF signals. A valid DTMF signal will set bit 5 of the Status

Register to 1 for as long as the signal is detected. The DTMF signal is then decoded and output in bits 0

to 3 of the Status Register.

The programmable tone pair detector includes two separate tone detectors (see Figure 9a). The first

detector will set bit 6 of the Status Register for as long as a valid signal is detected, the second detector

sets bit 7, and bit 10 of the Status Register will be set when both tones are detected. The frequency and

bandwidth of each detector can be set in the Programming Register. Without programming, the default

values in the Programming Register are set for 2130 and 2750 Hz detection.

The Call Progress detector measures the amplitude of the signal at the output of a 275 Hz - 665 Hz

bandpass filter and sets bit 10 of the Status Register to 1 when the signal level exceeds the

measurement threshold.

10

0

-10

-20

dB

-30

-40

-50

-60

0

0.5

1

1.5

2

2.5

3

3.5

4

kHz

Figure 5a Response of the Call Progress Filter

The Answer Tone detector measures both amplitude and frequency of the received signal and sets bit 6

or bit 7 respectively of the Status Register when a valid 2225Hz or 2100Hz signal is received.

© 2002 Consumer Microcircuits Limited

15

D/860/5

Share Link: