CMX860 Ver la hoja de datos (PDF) - CML Microsystems Plc

Número de pieza

componentes Descripción

Fabricante

CMX860

Telephone Signalling Transceiver

CML Microsystems Plc 

Telephone Signalling Transceiver / Least Cost Router

CMX860

1.5.2 FSK Modulator

Serial data from the USART is fed to the FSK modulator. One of two frequencies is generated according

to the current transmit data bit.

1.5.3 Tx Filter and Equaliser

The FSK modulator output signal is fed through the Transmit Filter and Equaliser block which limits the

out-of-band signal energy to acceptable limits. When transmitting 1200bps FSK, this block includes a

fixed compromise line equaliser which may be enabled or disabled by bit 10 of the General Control

Register. The amount of Tx equalisation provided compensates for one quarter of the relative amplitude

and delay distortion of ETS Test Line 1 over the frequency band used.

1.5.4 DTMF/Tones Generator

In DTMF/Tones mode this block generates DTMF signals or single or dual frequency tones.

1.5.5 Tx Level Control and Output Drivers

The CMX860 generated signal (if present) from the FSK/DTMF/Tones Generator is passed through the

programmable Tx Level Control before being passed to the switched paths controlled by the Analogue

Signal Path Register. The Tx Output Drivers have symmetrical outputs to provide sufficient line voltage

swing at low values of AVDD and to reduce harmonic distortion of the signal. The Drivers can also

transmit the signal from the other port (e.g. Phone Input to Line Driver) or can be independently set to

Bias or Powersaved – see Analogue Signal Path Register.

© 2002 Consumer Microcircuits Limited

14

D/860/5

Share Link: