BA3123F Ver la hoja de datos (PDF) - ROHM Semiconductor

Número de pieza

componentes Descripción

Fabricante

BA3123F

Ground Isolation Amplifier

ROHM Semiconductor 

BA3121F, BA3123F

●Applications

Technical Note

Fig.16

●Cautions on use

(1) Numbers and data in entries are representative design values and are not guaranteed values of the items.

(2) Although we are confident in recommending the sample application circuits, carefully check their characteristics further

when using them. When modifying externally attached component constants before use, determine them so that they

have sufficient margins by taking into account variations in externally attached components and the Rohm LSI, not only

for static characteristics but also including transient characteristics.

(3) Absolute maximum ratings

If applied voltage, operating temperature range, or other absolute maximum ratings are exceeded, the LSI may be

damaged. Do not apply voltages or temperatures that exceed the absolute maximum ratings. If you think of a case in

which absolute maximum ratings are exceeded, enforce fuses or other physical safety measures and investigate how

not to apply the conditions under which absolute maximum ratings are exceeded to the LSI.

(4) GND potential

Make the GND pin voltage such that it is the lowest voltage even when operating below it. Actually confirm that the

voltage of each pin does not become a lower voltage than the GND pin, including transient phenomena.

(5) Thermal design

Perform thermal design in which there are adequate margins by taking into account the allowable power dissipation in

actual states of use.

(6) Shorts between pins and misinstallation

When mounting the LSI on a board, pay adequate attention to orientation and placement discrepancies of the LSI. If it

is misinstalled and the power is turned on, the LSI may be damaged. It also may be damaged if it is shorted by a

foreign substance coming between pins of the LSI or between a pin and a power supply or a pin and a GND.

(7) Operation in strong magnetic fields

Adequately evaluate use in a strong magnetic field, since there is a possibility of malfunction.

(8) The capacitors of 2pin (Vm1), and 6pin (Vm2) should maintain the ratio of 2:1 for ripple removal characteristics.

Maintaining this ratio will not cause ripple removal rate to reduce significantly even if the capacitance reduces to a half.

(9) Setting the capacitor to the double or half will make the CMRR in the low range to +6dB or -6dB respectively (Fig. 10)

www.rohm.com

7/8

© 2009 ROHM Co., Ltd. All rights reserved.

2009.08 - Rev.A

Share Link: