M52737SP Ver la hoja de datos (PDF) - MITSUBISHI ELECTRIC
Número de pieza
componentes Descripción
Fabricante
M52737SP Datasheet PDF : 15 Pages
| |||
MITSUBISHI ICs (Monitor)
M52737SP
3-CHANNEL VIDEO PREAMPLIFIER WITH OSD MIXING, RETRACE BLANKING
APLLICATION METHOD FOR M52737SP
1) CLAMP PULSE INPUT
Input positive pulse.
The calculating of clamp pulse threshold voltage is by the method
as shown right.
The voltage more than 2.2V is limited.
Recommended clamp pulse voltage is as the Fig. shown right.
pulse width is recommended
above 15kHz, 1.0µsec
above 30kHz, 0.5µsec
above 64kHz, 0.3µsec .
The clamp pulse circuit in ordinary set is a long roundabout way,
and beside high voltage, sometimes connected to external
terminal, it is very easy affected by large surge.
Therefore, the Fig. shown right is recommended.
VTH= 2.2V-Diode×1
=1.5V
VTH (1.5V)
2.5 to 5.0V
0V
2-1) Brightness terminal
Used range is 1 to 5V
Control characteristic is shown in the right Fig. .
5
4
3
2
1
0
1
2
3
4
5
6
Brightness Voltage (V)
2-2) Sub brightness
There is no sub brightness control function in this IC.
2-3) Hold capacitor
It is necessary more than 0.01µF for this IC (when fH=15kHz).
In fact it is changed according with hold time (except clamping
time). It is need more capacitance for longer the hold time. In other
way, for application. The smaller the capacitance is, the higher the
response. The more the capacitance is, the more stable the action.
According to signal, it is free to set the value. (especially the status
of pulse for vertical sync timing).
18
2) Brightness action
signal
–
+
DC level shift
–
+
3) BLK (for OSD) input terminal
⋅ Input type is open base (reference to page 4).
⋅ Threshold voltage is 2.5V.
⋅ If input of OSD signal without input of BLK pulse, the action will
be strange. Therefore, it is necessary to input BLK pulse when
input of OSD signal.
⋅ Grounding this terminal when the OSD function is not used.
⋅ If overlay OSD display period with clamp pulse period, the action
will be strange. The method for this situation, recommended
external circuit is as the right Fig.
VCC
C/P
18
BLK
(for OSD)
19
brightness
1
(1 to 5V)
The upper figure is principle
9
Share Link: 