AZ12001 Ver la hoja de datos (PDF) - Arizona Microtek, Inc

Número de pieza

componentes Descripción

Fabricante

AZ12001

Phase-Locked Loop Clock Generator

Arizona Microtek, Inc 

AZ12000

AZ12001

Internal VCO

The internal VCO is designed for reliable, low jitter operation up to 800 MHz. It operates as a single terminal negative

impedance type circuit.

The tank circuit should have a minimum Q of 12 for reliable operation. The series combination of CV and C1 resonate

with L1 to set the operating frequency. The VCO control voltage is isolated through an inductor or resistor and changes

the varactor capacitance based on that control voltage. Note that the CPPOL pin should be tied high for internal VCO

operation since the tank frequency decreases with increasing control voltage.

VCOVCC

VCO

CONTROL

VOLTAGE

VARACTOR

CV

L2

R1

C2

TANK

L1

TANK

VCO

Figure 3 Internal VCO with Tank

External VCO

When VCOSEL is high, the internal VCO is disabled and the EXTVCO, E¯ ¯X¯T¯V¯ ¯C¯O¯ pair is enabled. That input pair is

sine wave and PECL compatible.

The CPPOL pin sets the frequency slope polarity based on the operation of the external VCO. When CPPOL is low, the

charge pump generates pulses for an integrator and loop filter assuming the VCO frequency goes lower as the integrator

output voltage increases. When CPPOL is high, pulses are generated for a VCO in which the frequency goes higher as

the integrator output voltage increases.

January 2005 * REV - 3

www.azmicrotek.com

10

Share Link: