ATTINY88(2008) Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

ATTINY88
(Rev.:2008)

8-bit Microcontroller with 4/8K Bytes In-System Programmable Flash

Atmel Corporation 

1.1.8

AVCC

pins that are externally pulled low will source current if the pull-up resistors are activated. The

Port D pins are tri-stated when a reset condition becomes active, even if the clock is not running.

The various special features of Port D are elaborated in “Alternate Functions of Port D” on page

70.

AVCC is the supply voltage pin for the A/D converter and a selection of I/O pins. This pin should

be externally connected to VCC even if the ADC is not used. If the ADC is used, it is recom-

mended this pin is connected to VCC through a low-pass filter, as described in “Analog Noise

Canceling Techniques” on page 163.

The following pins receive their supply voltage from AVCC: PC7, PC5:0 and (in 32-lead pack-

ages) PA1:0. All other I/O pins take their supply voltage from VCC.

4 ATtiny48/88

8008BS–AVR–06/08

Share Link: