ATMEGA8A Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

ATMEGA8A

8-bit Atmel Microcontroller with 8KB In-System Programmable Flash

Atmel Corporation 

9. Errata

The revision letter in this section refers to the revision of the ATmega8A device.

9.1 ATmega8A, rev. L

• First Analog Comparator conversion may be delayed

• Interrupts may be lost when writing the timer registers in the asynchronous timer

• Signature may be Erased in Serial Programming Mode

• CKOPT Does not Enable Internal Capacitors on XTALn/TOSCn Pins when 32kHz Oscillator is Used to Clock the

Asynchronous Timer/Counter2

• Reading EEPROM by using ST or STS to set EERE bit triggers unexpected interrupt request

1. First Analog Comparator conversion may be delayed

If the device is powered by a slow rising VCC, the first Analog Comparator conversion will take longer than

expected on some devices.

Problem Fix / Workaround

When the device has been powered or reset, disable then enable theAnalog Comparator before the first

conversion.

2. Interrupts may be lost when writing the timer registers in the asynchronous timer

The interrupt will be lost if a timer register that is synchronous timer clock is written when the asynchronous

Timer/Counter register (TCNTx) is 0x00.

Problem Fix / Workaround

Always check that the asynchronous Timer/Counter register neither have the value 0xFF nor 0x00 before writ-

ing to the asynchronous Timer Control Register (TCCRx), asynchronous Timer Counter Register (TCNTx), or

asynchronous Output Compare Register (OCRx).

3. Signature may be Erased in Serial Programming Mode

If the signature bytes are read before a chiperase command is completed, the signature may be erased caus-

ing the device ID and calibration bytes to disappear. This is critical, especially, if the part is running on internal

RC oscillator.

Problem Fix / Workaround:

Ensure that the chiperase command has exceeded before applying the next command.

4. CKOPT Does not Enable Internal Capacitors on XTALn/TOSCn Pins when 32kHz Oscillator is Used to

Clock the Asynchronous Timer/Counter2

When the internal RC Oscillator is used as the main clock source, it is possible to run the Timer/Counter2

asynchronously by connecting a 32kHz Oscillator between XTAL1/TOSC1 and XTAL2/TOSC2. But when the

internal RC Oscillator is selected as the main clock source, the CKOPT Fuse does not control the internal

capacitors on XTAL1/TOSC1 and XTAL2/TOSC2. As long as there are no capacitors connected to

XTAL1/TOSC1 and XTAL2/TOSC2, safe operation of the Oscillator is not guaranteed.

Problem Fix / Workaround

Use external capacitors in the range of 20 - 36 pF on XTAL1/TOSC1 and XTAL2/TOSC2. This will be fixed in

ATmega8A Rev. G where the CKOPT Fuse will control internal capacitors also when internal RC Oscillator is

selected as main clock source. For ATmega8A Rev. G, CKOPT = 0 (programmed) will enable the internal

capacitors on XTAL1 and XTAL2. Customers who want compatibility between Rev. G and older revisions,

must ensure that CKOPT is unprogrammed (CKOPT = 1).

ATmega8A [DATASHEET]

11

8159ES–AVR–02/2013

Share Link: