AT29LV512 Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

AT29LV512

512K (64K x 8) 3-volt Only Flash Memory

Atmel Corporation 

Features

• Single Supply Voltage, Range 3V to 3.6V

• 3-volt Only Read and Write Operation

• Software Protected Programming

• Low-power Dissipation

– 15 mA Active Current

– 50 µA CMOS Standby Current

• Fast Read Access Time – 120 ns

• Sector Program Operation

– Single-cycle Reprogram (Erase and Program)

– 512 Sectors (128 Bytes/Sector)

– Internal Address and Data Latches for 128 Bytes

• Fast Sector Program Cycle Time – 20 ms Max

• Internal Program Control and Timer

• DATA Polling for End of Program Detection

• Typical Endurance > 10,000 Cycles

• CMOS and TTL Compatible Inputs and Outputs

• Green (Pb/Halide-free) Packaging Option

512K (64K x 8)

3-volt Only

Flash Memory

AT29LV512

1. Description

The AT29LV512 is a 3-volt-only in-system Flash programmable erasable read-only

memory (PEROM). Its 512K of memory is organized as 65,536 words by 8 bits. Man-

ufactured with Atmel’s advanced nonvolatile CMOS technology, the device offers

access times to 120 ns with power dissipation of just 54 mW over the industrial tem-

perature range. When the device is deselected, the CMOS standby current is less

than 50 µA. The device endurance is such that any sector can typically be written to in

excess of 10,000 times.

To allow for simple in-system reprogrammability, the AT29LV512 does not require

high input voltages for programming. Three-volt-only commands determine the opera-

tion of the device. Reading data out of the device is similar to reading from an

EPROM. Reprogramming the AT29LV512 is performed on a sector basis; 128 bytes

of data are loaded into the device and then simultaneously programmed.

During a reprogram cycle, the address locations and 128 bytes of data are captured at

microprocessor speed and internally latched, freeing the address and data bus for

other operations. Following the initiation of a program cycle, the device will automati-

cally erase the sector and then program the latched data using an internal control

timer. The end of a program cycle can be detected by DATA polling of I/O7. Once the

end of a program cycle has been detected, a new access for a read or program can

begin.

0177O–FLASH–9/08

Share Link: