AS1916 Ver la hoja de datos (PDF) - austriamicrosystems AG

Número de pieza

componentes Descripción

Fabricante

AS1916

Microprocessor Supervisory Circuits with Manual Reset and Watchdog

austriamicrosystems AG 

AS1916 - AS1918

Datasheet - Detailed Description

8.2 Watchdog Input

The integrated watchdog feature can be used to monitor processor activity via pin WDI, and can detect pulses as short as 50ns. The watchdog

requires that the processor toggle the watchdog logic input at regular intervals, within a specified minimum timeout period (1.5s, typ). A reset is

asserted for the reset timeout period. As long as reset is asserted, the timer remains cleared and is not incremented. When reset is deasserted,

the watchdog timer starts counting (Figure 11).

Note: The watchdog timer can be cleared with a reset pulse or by toggling WDI.

Figure 11. Watchdog Timing Relationship

alid VCC

v RESETN

ill WDI

t The RESET signal is the inverse of the RESETN signal.

tRST

tRP

tWD

tRP

s AG nt s The watchdog is internally driven low during most (87.5%) of the watchdog timeout period (see tWD on page 5) and high for the rest of the

e watchdog timeout period. When pin WDI is left unconnected, this internal driver clears the watchdog timer every 1.4s. When WDI is tri-stated or

m t is not connected, the maximum allowable leakage current is 10µA and the maximum allowable load capacitance is 200pF.

Note: The watchdog function can be disabled by leaving pin WDI unconnected or connecting it to a tri-state output buffer.

a n 8.3 Manual Reset Input

o The active-low pin MRN is used to force a manual reset. This input can be driven by CMOS logic levels or with open-drain collector outputs.

c Pulling MRN low asserts a reset which will remain asserted as long as MRN is kept low, and for the timeout period (see tRP on page 4) after

MRN goes high (140ms min). The manual reset circuitry has an internal 50kΩ pullup resistor, thus it can be left open if not used.

l To create a manual-reset circuit, connect a normally open momentary switch from pin MRN to GND (see Figure 1 on page 1); external debounce

circuitry is not required in this configuration.

a If MRN is driven via long cables or the device is used in a noisy environment, a 0.1µF capacitor between pin MRN and GND will provide

Technic additional noise immunity.

www.austriamicrosystems.com/Supervisors/AS1916

Revision 1.04

8 - 14

Share Link: