AS1154 Ver la hoja de datos (PDF) - austriamicrosystems AG
Número de pieza
componentes Descripción
Fabricante
AS1154 Datasheet PDF : 15 Pages
| |||
AS1156/AS1154
Data Sheet - Applications
9 Applications
Table 5. Function Table
Input
INx
L
H
0.8V < VINx < 2.0V
Output
OUTx+
OUTx-
L
H
H
L
Undetermined
Undetermined
Figure 19. Typical Application Circuit
LVTTL/LVCMOS
Data Inputs
+3.3V
0.001µF
0.1µF
Tx
LVDS
Signals
107Ω
+3.3V
0.001µF
0.1µF
Rx
LVTTL/LVCMOS
Data Outputs
AS1156
AS1158
Single LVDS Receiver
100Ω Shielded Twisted Cable or Microstrip PC Board Traces
Power-Supply Bypassing
To bypass VCC, use high-frequency surface-mount ceramic 0.1µF and 0.001µF capacitors in parallel as close to the
device as possible, with the smaller valued capacitor closest to pin VCC.
Differential Traces
Input trace characteristics can adversely affect the performance of the AS1156/AS1154.
Use controlled-impedance PC board traces to match the cable characteristic impedance. The termination resistor is
also matched to this characteristic impedance.
Eliminate reflections and ensure that noise couples as common mode by running the differential traces near each
other.
Reduce skew by using matched trace lengths. Tight skew control is required to minimize emissions and proper data
recovery of the devices.
Route each channel’s differential signals very close to each other for optimal cancellation of their respective exter-
nal magnetic fields. Use a constant distance between the differential traces to avoid irregularities in differential
impedance.
Avoid 90° turns (use two 45° turns).
Minimize the number of vias to further prevent impedance irregularities.
Cables and Connectors
Supported transmission media include printed circuit board traces, backplanes, and cables.
Use cables and connectors with matched differential impedance (typically 100Ω) to minimize impedance mis-
matches.
Balanced cables such as twisted pair offer superior signal quality and tend to generate less EMI due to magnetic
field canceling effects. Balanced cables pick up noise as common mode, which is rejected by the LVDS receiver.
Avoid the use of unbalanced cables such as ribbon cable or simple coaxial cable.
www.austriamicrosystems.com
Revision 1.01
10 - 15
Share Link: 