AS1310 Ver la hoja de datos (PDF) - austriamicrosystems AG
Número de pieza
componentes Descripción
Fabricante
AS1310 Datasheet PDF : 20 Pages
| |||
Datasheet
AS1310
Ultra Low Quiescent Current, Hysteretic DC-DC Step-Up Converter
1 General Description
2 Key Features
The AS1310 is an ultra low IQ hysteretic step-up DC-DC converter
optimized for light loads (60mA), where it achieves efficiencies of up
to 92%.
lid AS1310 operates from a 0.7V to 3.6V supply and supports output
voltages between 1.8V and 3.3V. Besides the available AS1310
standard variants any variant with output voltages in 50mV steps are
available. See Ordering Information on page 18 for more information.
a If the input voltage exceeds the output voltage the device is in a
v feed-through mode and the input is directly connected to the output
voltage.
ill In light load operation, the device enters a sleep mode when most of
the internal operating blocks are turned off in order to save power.
This mode is active approximately 50µs after a current pulse
t provided that the output is in regulation.
G In order to save power the AS1310 features a shutdown mode,
s where it draws less than 100nA. During shutdown mode the battery
is disconnected from the output.
A3 Applicationst The AS1310 also offers adjustable low battery detection. If the
s n battery voltage decreases below the threshold defined by two
external resistors on pin LBI, the LBO output is pulled to logic low.
e The AS1310 is available in a TDFN (2x2) 8-pin package.
m t Figure 1. AS1310 Typical Application Diagram
Input voltage range: 0.7V to 3.6V
Fixed output voltage range: 1.8V to 3.3V
Output current: 60mA @ VIN=0.9V, VOUT=1.8V
Quiescent current: 1µA (typ.)
Shutdown current: < 100nA
Up to 92% efficiency
Output disconnect in shutdown
Feedthrough mode when VIN > VOUT
Adjustable low battery detection
No external diode or transistor required
Over temperature protection
TDFN (2x2) 8-pin package
The AS1310 is an ideal solution for single and dual cell powered
devices as blood glucose meters, remote controls, hearing aids,
wireless mouse or any light-load application.
aal con VIN
0.7V to 3.6V
ic C1
Techn 22µF
L1
6.8µH
8
VIN
R1
1
R2
LBI
On
7
Off
EN
3 LX
AS1310
2 GND
6
LBO
4
VOUT
5
REF
Low Battery Detect
R3
CREF
100nF
C2
22µF
VOUT
1.8V to 3.3V
www.austriamicrosystems.com/DC-DC_Step-Up/AS1310
Revision 1.8
1 - 19
Share Link: 