MSM7704-01GS-K Ver la hoja de datos (PDF) - Oki Electric Industry
Número de pieza
componentes Descripción
Fabricante
MSM7704-01GS-K Datasheet PDF : 17 Pages
| |||
¡ Semiconductor
MSM7704-01/02/03
XSYNC
Transmit synchronizing signal input.
PCM output signal from the DOUT1 and DOUT2 pins is output in synchronization with this
transmit synchronizing signal. This synchronizing signal triggers the PLL and synchronizes all
timing signals of the transmit section.
This synchronizing signal must be synchronized in phase with BCLK.
The frequency should be 8 kHz ±50 ppm to guarantee the AC characteristics which are mainly
the frequency characteristics of the transmit section.
However, unless the frequency characteristics of the system used are strictly specified, this
device can operate in the range of 6 kHz to 9 kHz, but the electrical characteristics are not
guaranteed.
Setting this signal to logic "1" or "0" drives both transmit and receive circuits to power saving
state.
DOUT1
PCM signal output of channel 1 when the parallel mode is selected.
The PCM output signal is output from MSD in a sequential order, synchronizing with the rising
edge of the BCLK signal.
MSD may be output at the rising edge of the XSYNC signal, based on the timing between BCLK
and XSYNC.
This pin is in a high impedance state except during 8-bit PCM output. It is also in a high
impedance state during power-saving state or power-down state.
When the serial mode is selected, this pin is configured to be the output of serial multiplexed 2ch
PCM signal.
A pull-up resistor must be connected to this pin because it is an open drain output.
This device is compatible with the ITU-T recommendation on coding law and output coding
format.
The MSM7704-03 (A-law) outputs the character signal, inverting the even bits.
Input/Output Level
+Full scale
+0
–0
–Full scale
PCMIN/PCMOUT
MSM7704-02 (m-law)
MSM7704-03 (A-law)
MSD
MSD
1000 0000
1010 1010
1111 1111
1101 0101
0111 1111
0101 0101
0000 0000
0010 1010
6/17
Share Link: 