AM2302 Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Fabricante

AM2302

Temperature and humidity module

Unspecified 

should be to ensure that the work of the humidity sensor at the same temperature. With the release of heat of

electronic components share a printed circuit board, the installation should be as far as possible the sensor away from

the electronic components and mounted below the heat source, while maintaining good ventilation of the enclosure.

To reduce the thermal conductivity sensor and printed circuit board copper plating should be the smallest possible,

and leaving a gap between the two.

4. Light impact

Prolonged exposure to sunlight or strong ultraviolet radiation, and degrade performance.

5. Resume processing

Placed under extreme working conditions or chemical vapor sensor, which allows it to return to the status of

calibration by the following handler. Maintain two hours in the humidity conditions of 45℃ and <10% RH (dry);

followed by 20-30℃ and> 70% RH humidity conditions to maintain more than five hours.

6. Wiring precautions

The quality of the signal wire will affect the quality of the voltage output, it is recommended to use high quality

shielded cable.

7. Welding information

Manual welding, in the maximum temperature of 300℃ under the conditions of contact time shall be less than 3

seconds.

8. Product upgrades

Details, please the consultation Aosong electronics department.

9、The license agreement

Without the prior written permission of the copyright holder, shall not in any form or by any means, electronic

or mechanical (including photocopying), copy any part of this manual, nor shall its contents be communicated to a

third party. The contents are subject to change without notice.

The Company and third parties have ownership of the software, the user may use only signed a contract or

software license.

10、Warnings and personal injury

This product is not applied to the safety or emergency stop devices, as well as the failure of the product may

result in injury to any other application, unless a particular purpose or use authorized. Installation, handling, use or

maintenance of the product refer to product data sheets and application notes. Failure to comply with this

recommendation may result in death and serious personal injury. The Company will bear all damages resulting

personal injury or death, and waive any claims that the resulting subsidiary company managers and employees and

agents, distributors, etc. that may arise, including: a variety of costs, compensation costs, attorneys' fees, and so on.

Aosong(Guangzhou) Electronics Co.,Ltd.

TEL：020-36042809 / 36380552

-9-

www.aosong.com

Share Link: