AG403-89 Ver la hoja de datos (PDF) - WJ Communications => Triquint

Número de pieza

componentes Descripción

Fabricante

AG403-89

InGaP HBT Gain Block

WJ Communications => Triquint 

AG403-89

InGaP HBT Gain Block

Product Information

AG403-89 (SOT-89 Package) Mechanical Information

This package may contain lead-bearing materials. The plating material on the leads is SnPb.

Outline Drawing

Product Marking

The AG403-89 will be marked with an

“AG403” designator. An alphanumeric lot

code (“XXXX-X”) is also marked below the

part designator on the top surface of the

package.

Tape and reel specifications for this part are

located on the website in the “Application

Notes” section.

MSL / ESD Rating

Land Pattern

ESD Rating: Class 1C

Value:

Passes at 1000 V min.

Test:

Human Body Model (HBM)

Standard: JEDEC Standard JESD22-A114

ESD Rating: Class IV

Value:

Passes at 1000 V min.

Test:

Charged Device Model (CDM)

Standard: JEDEC Standard JESD22-C101

MSL Rating: Level 3 at +235° C convection reflow

Standard: JEDEC Standard J-STD-020

Thermal Specifications

Parameter

Rating

Operating Case Temperature

Thermal Resistance, Rth (1)

Junction Temperature, Tjc (2)

-40 to +85°C

191° C/W

141° C

1. The thermal resistance is referenced from the hottest

part of the junction to the ground tab (pin 4).

2. This corresponds to the typical biasing condition of

+4.91V, 60 mA at an 85°C case temperature. A

minimum MTTF of 1 million hours is achieved for

junction temperatures below 177 °C.

MTTF vs. GND Tab Temperature

1000

100

10

1

60 70 80 90 100

Tab Temperature (°C)

Mounting Config. Notes

1. Ground / thermal vias are critical for the proper

performance of this device. Vias should use a .35mm

(#80 / .0135”) diameter drill and have a final plated

thru diameter of .25 mm (.010”).

2. Add as much copper as possible to inner and outer

layers near the part to ensure optimal thermal

performance.

3. Mounting screws can be added near the part to fasten

the board to a heatsink. Ensure that the ground /

thermal via region contacts the heatsink.

4. Do not put solder mask on the backside of the PC board

in the region where the board contacts the heatsink.

5. RF trace width depends upon the PC board material

and construction.

6. Use 1 oz. Copper minimum.

7. All dimensions are in millimeters (inches). Angles are

in degrees.

110

Specifications and information are subject to change without notice

WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6621 • e-mail: sales@wj.com • Web site: www.wj.com

Page 4 of 6 June 2005

Share Link: