A4953ELJTR-T Ver la hoja de datos (PDF) - Allegro MicroSystems

Número de pieza

componentes Descripción

Fabricante

A4953ELJTR-T

Full-Bridge DMOS PWM Motor Drivers

Allegro MicroSystems 

A4952 and

A4953

Full-Bridge DMOS PWM Motor Drivers

Application Information

Sense Pin (LSS)

In order to use PWM current control, a low-value resistor is

placed between the LSS pin and ground for current sensing pur-

poses. To minimize ground-trace IR drops in sensing the output

current level, the current sensing resistor should have an indepen-

dent ground return to the star ground point. This trace should be

as short as possible. For low-value sense resistors, the IR drops in

the PCB can be significant, and should be taken into account.

When selecting a value for the sense resistor be sure not to

exceed the maximum voltage on the LSS pin of ±500 mV at

maximum load. During overcurrent events, this rating may be

exceeded for short durations.

thermal pad of the device makes a good location for the star

ground point. The exposed pad can be connected to ground for

this purpose.

Layout

The PCB should have a thick ground plane. For optimum electri-

cal and thermal performance, the A4952/A4953 must be soldered

directly onto the board. On the underside of the A4952/A4953

package is an exposed pad, which provides a path for enhanced

thermal dissipation. The thermal pad must be soldered directly to

an exposed surface on the PCB in order to achieve optimal ther-

mal conduction. Thermal vias are used to transfer heat to other

layers of the PCB.

Ground

A star ground should be located as close to the A4952/ A4953

as possible. The copper ground plane directly under the exposed

The load supply pin, VBB, should be decoupled with an electro-

lytic capacitor (typically 100 μF) in parallel with a lower valued

ceramic capacitor placed as close as practicable to the device.

Layout for the A4952 (LY package)

GND

GND

OUT2

RS

A4952

PCB

Thermal Vias

Solder

Trace (2 oz.)

Signal (1 oz.)

Ground (1 oz.)

Thermal (2 oz.

C1

C2

BULK

CAPACITANCE

OUT1

VBB

1

FLTn

RTRY

IN2

IN1

VREF

A4952

PAD

GND

OUT2

LSS

RS

OUT1

VBB

C1

VBB

C2

GND

GND

Bill of Materials

Item

Reference

1

RS

2

C1

3

C2

Value

0.25

(for VREF = 5 V, IOUT = 2 A)

0.22

100

Units

Ω

μF

μF

Description

2512, 1 W, 1% or better,

carbon film chip resistor

X5R minimum, 50 V or greater

Electrolytic, 50 V or greater

Allegro MicroSystems, LLC

7

115 Northeast Cutoff

Worcester, Massachusetts 01615-0036 U.S.A.

1.508.853.5000; www.allegromicro.com

Share Link: