A1280A Ver la hoja de datos (PDF) - Actel Corporation

Número de pieza

componentes Descripción

Fabricante

A1280A

HiRel FPGAs

Actel Corporation 

Absolute Maximum Ratings1

Free air temperature range

Symbol

Parameter

Limits

Units

VCC

DC Supply Voltage2, 3, 4 –0.5 to +7.0

V

VI

Input Voltage

–0.5 to VCC +0.5 V

VO

Output Voltage

–0.5 to VCC +0.5 V

IIO

I/O Source Sink

Current5

±20

mA

TSTG Storage Temperature

–65 to +150 °C

Notes:

1. Stresses beyond those listed under “Absolute Maximum Ratings”

may cause permanent damage to the device. Exposure to

absolute maximum rated conditions for extended periods may

affect device reliability. Devices should not be operated outside

the recommended operating conditions.

2. VPP = VCC , except during device programming.

3. VSV = VCC , except during device programming.

4. VKS = GND , except during device programming.

5. Device inputs are normally high impedance and draw extremely

low current. However, when input voltage is greater than VCC +

0.5V or less than GND – 0.5V, the internal protection diode will be

forward biased and can draw excessive current.

Recommended Operating Conditions

Parameter

Commercial Military

Units

Temperature

Range1

Power Supply

Tolerance2

0 to +70 –55 to +125 °C

±5

±10

%VCC

Notes:

1. Ambient temperature (TA) is used for commercial and

industrial; case temperature (TC) is used for military.

2. All power supplies must be in the recommended operating range.

For more information, refer to the Power-Up Design Considerations

application note at http://www.actel.com/appnotes.

Electrical Specifications

Commercial

Military

Symbol Parameter

Test Condition

Min.

Max.

Min.

Max.

VOH1, 2

VOL1, 2

VIH

VIL

IIN

IOZ

CIO

ICC(S)

HIGH Level Output

LOW Level Output

HIGH Level Input

IOH = –4 mA (CMOS)

IOH = –6 mA (CMOS)

IOL = +6 mA (CMOS)

TTL Inputs

LOW Level Input

TTL Inputs

Input Leakage

3-state Output Leakage

I/O Capacitance3, 4

VI = VCC or GND

VO = VCC or GND

Standby VCC Supply Current VI = VCC or GND, IO = 0 mA

ACT 1

3.84

2.0

–0.3

–10

–10

0.33

VCC + 0.3

0.8

+10

+10

10

3

3.7

2.0

–0.3

–10

–10

0.4

VCC + 0.3

0.8

+10

+10

10

20

ACT 2/3/1200XL/3200DX

2

20

ICC(D)

Dynamic VCC Supply Current

See the “Power Dissipation” section on page 11.

Notes:

1. Actel devices can drive and receive either CMOS or TTL signal levels. No assignment of I/Os as TTL or CMOS is required.

2. Tested one output at a time, VCC = min.

3. Not tested; for information only.

4. VOUT = 0V, f = 1 MHz

Units

V

V

V

V

V

µA

µA

pF

mA

mA

10

Share Link: