L5973AD Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

L5973AD

2 A switch step down switching regulator

STMicroelectronics 

L5973AD

Functional description

4.6

PWM comparator and power stage

This block compares the oscillator sawtooth and the error amplifier output signals

generating the PWM signal for the driving stage. The power stage is a very critical block

cause it has to guarantee a correct turn on and turn OFF of the PDMOS. The turn ON of the

power element, or better, the rise time of the current at turn on, is a very critical parameter to

compromise.

At a first approach, it looks like the faster it is the rise time, the lower are the turn on losses.

But there is a limit introduced by the recovery time of the recirculation diode. In fact when the

current of the power element equals the inductor current, the diode turns off and the drain of

the power is free to go high. But during its recovery time, the diode can be considered as an

high value capacitor and this produces a very high peak current, responsible of many

problems:

● Spikes on the device supply voltage that cause oscillations (and thus noise) due to the

board parasitics.

● Turn ON overcurrent causing a decrease of the efficiency and system reliability.

● Big EMI problems.

● Shorter freewheeling diode life.

The fall time of the current during the turn off is also critical. In fact it produces voltage

spikes (due to the parasitics elements of the board) that increase the voltage drop across

the PDMOS.

In order to minimize all these problems, a new topology of driving circuit has been used and

its block diagram is shown in Figure 7.

The basic idea is to change the current levels used to turn on and off the power switch,

according with the PDMOS status and with the gate clamp status.

This circuitry allow to turn off and on quickly the power switch and to manage the above

question related to the freewheeling diode recovery time problem.

The gate clamp is necessary to avoid that Vgs of the internal switch goes higher than

Vgsmax. The ON/OFF Control block avoids any cross conduction between the supply line

and ground.

11/21

Share Link: